Eddie Motorsports MS107-60 User Manual

1

LS Chevrolet

INSTALLATION INSTRUCTIONS

Engine Prep:

 Disconnect battery
 Remove existing accessory drive and water pump.
 Remove crank pulley/damper and save the crank bolt for later.
 Clean front of block.
 Inspect front crank seal and replace if necessary.
 Install crank hub and damper per ATI LS1/LS7 Super Damper instruction sheet.

Install Damper

Follow the instructions from the manufacturer to correctly install the balancer hub and damper assembly.

2

Install Water Pump and Rear Alternator Bracket:

1. Install three M8 studs x 92 mm with anti seize to the passenger side of the block. They should stick out

3”. Use the double nuts provided for install if needed.

2. Install two M8 studs x 118 mm with anti seize to the driver side of the block. They should stick out 4”.

3. Install water pump gaskets and water pump over studs.

3

4. Install three 3/4 x 2.55 spacer posts with anti seize to passenger side studs.

5. Install rear alternator bracket and two 3/4 x 1.41 spacer posts with anti seize to driver side studs.

6. Install one M8 cap screw x 95mm with anti seize thru rear alternator bracket and water pump.

 Tighten all spacers and cap screw at this time.

4

Install Rear Compressor Bracket:

1. Attach rear compressor bracket to water pump using two M10 cap screws x 20mm with anti

seize.

Install Compressor Bracket:

1. Install compressor bracket to passenger side spacer posts with three M8 x 25mm cap screws and

washers with anti seize. Finger tighten.

Note: Make sure waterneck and thermostat are installed on water pump first.

Install A/C Compressor:

1. Install A/C compressor using two M8 x 25mm cap screws and anti sieze. Finger tighten.