Eddie Motorsports MS107-55 User Manual

Small Block Chevrolet

INSTALLATION INSTRUCTIONS

Engine Prep:

 Disconnect battery
 Remove existing alternator, a/c compressor, and brackets.
 Remove all pulleys and brackets
 Clean front of block
 Chase the tapped holes in block with a 3/8-16 thread chaser or tap.

Install Mounting Studs:

1. Apply RTV silicone to one end of each mounting stud.

2. Install the 3/8-16 x 4 stud into the bottom passenger side. It should stick out 3 1/2”.

3. Install three remaining studs, sticking out 2 1/2”.

Note: Use the double nuts provided for install if needed.

Install Compressor and Alternator Brackets:

1. Install four large and two small O rings in compressor and alternator brackets.

2. Slide brackets over studs as shown

Install Power Steering Bracket:

1. Install power steering bracket using two 3/8-16 x 2” cap screws with anti-seize. Finger

tighten.

Install Water Pump and Spacer Posts:

1. Slide water pump over studs.

2. Apply anti seize to the end of the studs.

3. Install the short (1.85”) spacer post to bottom passenger stud