Eddie Motorsports MS107-50 User Manual

1

Big Block Chevrolet

INSTALLATION INSTRUCTIONS

Engine Prep:

 Disconnect battery
 Remove existing alternator, a/c compressor, and brackets.
 Remove all pulleys and brackets
 Clean front of block
 Chase the tapped holes in block with a 3/8-16 thread chaser or tap.

2

Install Mounting Studs:

1. Apply RTV silicone to one end of each mounting stud.

2. Install the four 3/8-16 x 3 studs into the engine block. They should stick out 2”.

Note: Use the double nuts provided for install if needed.

Install Compressor and Alternator Brackets:

1. Install four O rings in compressor and alternator brackets as shown.

2. Slide brackets over studs.

3

Install Power Steering Bracket:

1. Install power steering bracket using two 7/16-14 x 2-1/4” cap screws with anti-seize. Finger

tighten.

Install Water Pump and Spacer Posts:

1. Slide water pump over studs.

2. Apply anti seize to the end of the studs.

3. Install four (3/4 x 3”) spacer posts.

4. Tighten all spacer posts and two cap screws at this time.