Edco Electronics BTSPK36 User Manual

② Short p res s to p aus e playi ng mu si c.

① ON/OFF

② Single click: play, pause

③ V+ / NEXT

④ V- / PREV

②

⑤ Hands-free call

③ Long pr ess t o in cre ase the v olu me ,

Short p res s fo r nex t song.

④ Long pr ess t o de cli ne the vo lum e,

Short p res s fo r abo ve song .

⑤ Also if y ou ha ve a c all , press t his b ut ton t o hang up o r han g

on the ph one .

⑥ USB recharge port

①

③

⑤

1. Pr oduct s ize: 98x 88 x43 mm

2.Met al: ABS

3. DC: Bu ilt-i n recha rgeab le Lith ium-i on b att er y 300 mA h

4.BT di sta nc e: 10 m

5.Fre quenc y respo nse ran ge: 280 Hz-20 KH z

6.Sen sitiv ity:8 0db+2 db

7.Spe aker:Φ4 5mm 4Ω3W

8.Pla ying ti me:2- 3 hrs

④

⑥

can sea rch for “ Q5 0" on y ou r pho ne t o pair, af ter con necte d
succe ssful ly, you ca n play mu sic; If y ou want t o switc h pairi ng
other m obile d ev ice s ne ed to c ut o ff th e conne ction o f ex ist in g
equip ment in to p air in g mod e;

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

IC STATEMENT

This device complies with Industry Canada’s licence-

exempt RSSs. Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation

of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts d

e licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire d

e brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le b

rouillage est susceptible d'en compromettre le fonctionnement.