Edco Electronics BTSPK34 User Manual

Bluetooth Speaker

BTSPK34

E-1

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions carefully.

2. Keep these instructions in a safe place.

3. Follow all instructions.

4. Do not use this product near water.

5. Cleaning: Do not use liquid cleaners or aerosol cleaners. Clean only with a dry damp cloth.

6. Do not place near any heat sources such as radiators, heat registers, stoves, or other apparatuses (including
amplifiers) that produce heat.

7. Only use attachments/accessories specified by the manufacturer.

8. Refer all servicing to qualified service personnel. Servicing is required when the product has been damaged in
any way, such as liquid has been spilled or objects have fallen into the product, the product has been exposed to
rain or moisture, does not operate normally, or has been dropped.

9. This product shall not be exposed to dripping or splashing water and that no object filled with liquids such as
vases shall be placed on or near the product.

10. Object Entry: Never push objects of any kind into this product through the openings.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.
WARNING

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.

IC Warning

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.

This device complies with Canadian ICES-003 and RSS-210

Thank you for your purchase.
Please visit our website at www.borne-lifestyle.com.

E-2

LOCATION OF CONTROLS

1. Mode Button

6. Micro SD Slot

2. Volume Up / Next Track

7. USB Jack

3. Microphone

8. ON/OFF Switch

4. Volume Down / Previous Track

9. Micro USB Charging Port

5. Play/Pause Control/ Call Answer/End

10. Charging Indicator

CHARGING THE SPEAKER

Using the Charging Cable provided, plug the Micro USB Tip into the Micro USB Charging Port and
plug the other end (USB Tip) into a USB port on your computer or USB wall charger (not included).
A red LED indicator light will illuminate while charging and turn off when completed.

A full charge will take approximately 4 to 5 hours.