Page 1
TRAFFIC LINE REMOVER
Equipment Development Co., Inc. sales@edcoinc.com • 800.638.3326 • edcoinc.com
TRAFFIC LINE REMOVERS ARE GREAT FOR ERASING LINES AND ROAD MARKINGS
WITHOUT EXCESSIVE SURFACE DAMAGE!
EDCO’s TLR-7 can be pushed or pulled by one person to remove unwanted traffic markings. The
TLR has a 7” grinding width, that can be moved side to side for a 24” working width creating
feathered edge surface patterns that blend into road surfaces.
•
Removes thermoplastic, paint & epoxy traffic markings
•
Added side-mounted weights supply extra removal pressure
•
Swivel caster wheels allow side to side motion for feathered edges
•
Tilt-Top Chassis for safe and easy cutter changes
•
Quick-release parking brake
•
Separate pressure control lets you adjust grinding pressure to suit changing road conditions
PRODUCTION RATE: 7” Working Width will grind approximately 700-1,000 Lineal
ft. per hour with EDCO TLR-7 Carbide Cutters
INCLUDES: 3–24 Bit Carbide Cutter Assemblies
IDEAL FOR: Removing traffic lines and markings • Removing painted and thermoplastic lines
EDCO’s LONG LASTING TLR-7 CARBIDE PIN CUTTERS WILL
LAST UP TO 60,000 LINEAL FEET OF MARKINGS. THE
BULLET-SHAPED CARBIDE BITS DO MINIMAL
DAMAGE TO THE ROAD SURFACE.
* RPM’s are based on the machine’s accessory speed. * NET HORSEPOWER STATEMENT - * As rated by the engine manufacturer. The power rating of the engine indicated in this document is the net power output tested on a production engine
for the engine model and measured in accordance with SAE j1349 at 3600 rpm. Mass production engines may vary from this value. Actual power output for the engine installed in the final machine will vary depending on numerous factors, including
the opening speed of the engine in application, environmental conditions, maintenance, and other variables.
TRAFFIC LINE REMOVER
MODEL # PART # POWER HORSE POWER PHASE AMPS * RPM’s BELTS LENGTH *WIDTH
HEIGHT
WEIGHT
TLR-7-11H
77500 Gasoline
*11 HP
N/A N/A 1826 Std. “V” Belts 46.5” 29” 36.5” 438 lbs
EXCLUSIVE TILT-TOP
CUTTER ACCESS
Safely change the cutter assembly with EDCO’s Tilt-Top
chassis. A spring-loaded latch
releases the power unit, which
is tilted up and out of the way.
The chassis rests securely on
the front nose bar until maintenance is complete.
TR-3 CUTTER ASSEMBLIES
24 BIT ASSEMBLY 48 BIT ASSEMBLY
PART # 26010 PART # 26020
• Aggressive removal of
thermoplastic lines
• Use on uneven, rough,
asphalt surfaces
• Minimum surface penetration
• Remove paint markings
• Remove tape lines
• Remove epoxy markings
• Ideal for use on asphalt
Loading...