Windows is a registered trademark of Microsoft Corporation in the United States and
other countries.
Fodor's Travel Guide, Copyright 2007 Fodor's Travel, a division of Random House, Inc.
WordNet. WordNet 2.1 Copyright 2005 by Princeton University.
Rick Steves' Audio Tours. Copyright 2005, Avalon Travel Publishing,
Co-authored by Rick Steves, Steve Smith, and Gene Openshaw. Cedar House Audio
Production.
The World Factbook. Copyright 2006, Central Intelligence Agency. The World Factbook is
prepared by the Central Intelligence Agency for the use of US Government officials, and
the style, format, coverage, and content are designed to meet their specific requirements.
The names of actual companies and products mentioned herein may be the trademarks
of their respective owners.
ECTACO, Inc. assumes no responsibility for any damage or loss resulting from the use of
this manual.
ECTACO, Inc. assumes no responsibility for any loss or claims by third parties which may
arise through the use of this product.
ECTACO, Inc. assumes no responsibility for any damage or loss caused by deletion of
data as a result of malfunction, repairs, or battery replacement. Be sure to back up all
important data on other media to avoid data loss.
The contents of this manual as well as software functionality are subject to change
without prior notice.
No part of this manual shall be reproduced, stored in a retrieval system, or transmitted by
any means, electronic, mechanical, photocopying, recording, or otherwise, without
permission from ECTACO, Inc.
2
ECTACO iTRAVL
®
User Manual
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
3
ECTACO iTRAVL
®
User Manual
CONTENTS
GENERAL DESCRIPTION............................................................................. 7
Adding or Editing Phrases and Voice Tags .......................................................... 38
Using Voice Tags.................................................................................................. 38
6
ECTACO iTRAVL
®
User Manual
GENERAL DESCRIPTION
INTRODUCTION
Congratulations on your purchase of the high-end class ECTACO iTRAVL® Hand-held
Electronic Language Teacher
product you have purchased is the result of the combined efforts of the ECTACO team of
linguists, engineers, and programmers. You are now the owner of one of the most
advanced electronic devices ever produced for translation purposes and language
studies.
ECTACO iTRAVL
®
features:
®
, Dictionary, Audio PhraseBook™ and Travel Guide! The
•Talking dictionary of 200,000 to 5,000,000 (depends on a language pair) general,
medical, technical, legal, and slang words and expressions with transcriptions,
samples of usage, part-of-speech labels, special queries and filtering capabilities
• WordNet dictionary – 70,000 words with definitions
• Unlimited voice function based on TTS (Text-to-Speech) technology
• Voice navigation to ‘first need’ phrases
• Phonetic transcription
• Instant reverse translation
• Look-up function
• Advanced word recognition and MorphoFinder™
• Professionally narrated Audio PhraseBook™ with more than 14,000 phrases per
language pair, multiple-language ECTACO Speech Recognition system
• Vector Ultima™ spell-checker
• State-of-the-art Full-text Machine Translation Program (for selected languages)
• ECTACO Speech Recognition based tutorial with graphical testing system
• Linguistic games: FlashCards, Pockets, Spell It Right, Translation Test
• Fodor's Travel Guide to 50 cities
• CIA World Factbook for over 180 countries
• Audio Tours for the Louvre Museum, the Orsay Museum, Versailles, the Historic Paris
Walk
7
ECTACO iTRAVL
®
User Manual
• Audio Player with mp3 support
• Calendar
• Tasks
• Size Equivalents
• Metric Conversion
• Local and World Time
• Voice Recorder
• Calculator
• Backlight
• SD slot
• mini-USB port
• Headset jack
Device is powered by AC/DC adapter (Travel Charger) and rechargeable battery (all
included in the standard package).
♦Note: Always use the original ECTACO iTRAVL
ECTACO, Inc.
®
accessories manufactured by
8
ECTACO iTRAVL
®
User Manual
GENERAL VIEW
The general view and essential features of ECTACO iTRAVL® are shown below:
Front Panel:
Back Panel:
9
ECTACO iTRAVL
Key Function(s)
On/Off Turn the device On or Off. When the device is on, press and hold the
LED Blinking blue – recording is in progress or data being transferred.
Microphone
Button
Speaker
Button
Left Soft Key
/Right Soft Key
®
On/Off button to turn the backlight On or Off.
Blinking red – SD card is being scanned, or the battery is critically
low.
Use speech recognition (press and hold). Move highlight up (press
and release). Page up.
Use speech function (press and hold). Move highlight down (press
and release). Page down.
Activate menu or perform touch-button action.
User Manual
POWER SUPPLY
ECTACO iTRAVL® is powered by a special Li-Polymer rechargeable battery. When the
battery becomes weak, the red LED signal starts blinking. In that case, the voice function
will be disabled in order to prevent excessive discharge of the battery and a resulting loss
of data in RAM. To restore full functionality of the device, recharge the battery as soon as
possible.
How to Recharge the Battery
• Make sure the battery is inserted in the battery compartment.
♦ Note: Only a special rechargeable battery, special charger, and special USB cable or
USB cradle may be used with your ECTACO iTRAVL
external power supply may cause failure of the device and will void the warranty.
10
®
. Use of an inappropriate
ECTACO iTRAVL
®
User Manual
•Connect the AC/DC adapter to your device via the mini-USB port (see GeneralView),
or connect your device to your PC using the special USB cable or USB cradle.
The red LED signal shows that the battery is recharging and the blue one shows it is
charged.
SD CARD
Before you start using your ECTACO iTRAVL®, please make sure the SD card (included
in the standard package) is installed into the SD slot of the device. If the card is not
installed, slide it into the slot located on the left edge of the device – the label of the card
face up, contacts face down. Push the card gently until it clicks into place. To eject the
card, just push it in slightly.
♦ Note: If the SD slot is covered, please detach the slot cover before you install the card.
INITIALIZATION
In the rare event that the data on the screen is corrupted or a program is not responding
properly, you will need to perform a reset.
The Reset button is located on the back of the device (see General View).
•Press the Reset button with the tip of the stylus. Never use a needle or a pin since it
can damage the device.
On completion of the reboot, you will see the calibration screen with five targets,
appearing one after another as you tap them with the stylus.
DISPLAY AND MAIN MENU
ECTACO iTRAVL® features a touch screen (240 x 320 pixels) with a windows-driven
graphical interface. The Main Menu consists of four sections, which visually organize
access to the ECTACO iTRAVL® applications.
♦Note: Tapping screen items is preferably done with the supplied pointing device
known as a stylus, which, when not in use, is kept in a special slot at the side of the
device's back panel (see General View).
Main Menu
•To display the Main Menu, turn the device on, exit the currently running application
and close the current section. The Main Menu consists of the following sections:
iTRANSLATE, iTRAVL, Extras, and iHELP.
At the top of the screen, you will see the battery life indicator.
11
ECTACO iTRAVL
®
User Manual
•Tap the battery life indicator to change the battery life picture to percentage value or a
chart.
The Main Menu sections are described below. The content of the Main Menu depends on
product model.
•Use the iTRANSLATE section to access Language Teacher
Dictionary, Audio PhraseBook, Text Translation (if available), and FlashCards.
®
, Dictionary, WordNet
• Use the iTRAVL section to access Fodor's Travel Guide, CIA World Factbook, Audio
Books, World Time, Calendar, Size Equivalents, Metric Conversion, and Cultural
Notes.
• Use the Extras section to access Audio Player, Tasks, Calculator, Settings, and Voice
Recorder.
• Use the iHELP section to manage voice tags.
• When in a section, tap the desired application name. Alternatively, highlight it and then
tap Select or press the corresponding soft key. The application will then open.
•To close an application, tap at the upper right of the screen. Alternatively, select
Exit, or use Menu / Exit.
•To close the current section, select Back.
Using the Voice Commands
•When in the Main Menu, press and hold the Microphone button. You will see a dialog
with two buttons: Correct and Wrong.
•Say the name of the desired section or application and then release the Microphone
button. The section or application will then open.
• When in a section, press and hold the Microphone button.
• Say the name of the desired application and then release the Microphone button. The
application will then open.
♦Note: When using voice commands, say Travel Guide for Fodor's Travel Guide and
World Factbook for CIA World Factbook.
Setting the Target Language
The Target Language setting is used in multilanguage models to set the target
language for applications found in the iTRANSLATE section of the Main Menu.
•When in the Main Menu, tap the emblem in the middle of the screen.
You will see the Select Language screen.
12
Loading...
+ 26 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.