Ecostrad SUNGLO Instructions Manual

INSTRUCTIONS FOR CARBON INFRARED HEATER
Model: ECOSTRAD SUNGLO
Introduction
This infrared heater contains a Helen lamp reflector heating system that provides even heat distribution.
The energy consumption of this infrared heater is 30 - 40% more efficient in comparison to
traditional electric alternatives. Infrared heaters are commonly used for indoor or outdoor spot
heating and are perfect for garages, outdoor patios, and workshops.
Warning
PLEASE READ THE FOLLOWING INFORMATION CAREFULLY: This infrared heater is designed for
safe operation. Nevertheless, installation, maintenance and operation of this appliance can be
dangerous if undertaken incorrectly. Observing the following procedures will reduce the risk of
fire, electric shock, and injury. It will also keep installation time to a minimum. Save these
instructions for future reference.
1.
Read the instructions carefully before using this heater.
2.
Remove the unit from its packaging and check to make sure it is in good condition before
using.
3.
Do not let children play with parts of the packaging (e.g. plastic bags).
4.
Check household voltage to ensure it matches the heater’s rated specification.
5.
Check the power cord and plug carefully before use to make sure that they are not damaged.
6.
Before unplugging the power cord, be sure to turn off the power. When powering the unit,
be sure your hands are dry to prevent electric shock.
7.
Do not use the heater near flammable objects or point the heater toward soft furnishings,
such as pillows, sofas, bedding etc. Curtains and drapes should be kept at least 1m from the
front of the heater, but as an additional precaution, always keep them to the sides and rear
of the appliance.
8.
Do not use near or in the immediate vicinity of a bath or swimming pool or any source of
liquid.
9.
To protect against electric shock, do not immerse the cord or plug in water or any other
liquid.
10.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this
may cause an electric shock, fire or damage to the heater.
11.
Always unplug the heater when not in use.
12.
Do not allow the cord to overhang any surfaces where it can be easily pulled down by
children.
13.
Do not put fingers or foreign objects into the grill while in operation.
14.
Do not leave the appliance unattended when in use.
15.
This heater is not intended for use in bathrooms, laundry rooms and similar indoor locations
where it may fall into a bathtub or other water container.
16.
No liability can be accepted for any damage caused by non-compliance with these
instructions or any other improper use or mishandling.
17.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities. It should not be used by inexperienced persons unless they
have been given supervision or instruction concerning the use of the appliance by a person
responsible for their safety. Children and vulnerable people should be supervised to ensure
they do not play with the appliance.
18.
If the supply cord is damaged in any way, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
19.
To prevent the overheating of this appliance, keep air inlets and outlets clean and free of
anything that may cause blockage. Check all inlets and outlets periodically to ensure they are
clear of any dirt or dust accumulation. Do not cover.
20.
Parts of the heater may exceed 200 °C. Contact with the heating tube, reflector, or metal
parts near the heating tube, can cause severe burns. Never let bare skin touch the hot
surfaces of the heater.
21.
Never place your hands beneath the heating elements.
22.
Always allow the heating elements to cool for at least 10 minutes before touching the
heating tube or any adjacent parts.
23.
This product contains recyclable materials. Do not dispose of this product with ordinary
household waste. Please contact your local authority for collection and disposal information.
Loading...
+ 5 hidden pages