E Core Technology NC696A Users Manual

DG-NGC WIRELESS I.GLOW CONTROLLER WITH LEDS

Instruction Manual

（English Version ）

E-CORE Technology (China) Co., Ltd

Thanks for selecting the GameCube wireless controller of RF 2.4GHZ
series producted by us ,in order to be more convenient and correct when
operating ,please read this intruction manual carefully !

Product introduction

GC wireless controlelr is adopting 2.4GHZ RF technology ,carrying the steady
connection ,far distance , low power wastage , beautiful outlook and nice
handle ,which make you experience personally when playing .

Technology Specification

1、Compatible with all the GameCube version console
2、Support TURBO function
3、Signal connection indication
4、Fixed ID codefunction
5、Low voltage indication
6、Automatically sleeping function to saving electricity
7、Skid-proof design to the grips
8、Available distance≥10 meters
9、Work voltage ：4.5V 3×1.5V AAA batteries

10.Automatically connection
11、Work current： 20mA Sleeping mode :100μA
12、Outlook size： Controller 150*100*65mm；receiver 28×36×
34mm
13、weight：169g

Product declaration :

Product function declaration ：

10、 Using illustration

1）、Open the battery cover，install the 1.5V 3 AAA batteries in the

battery case comply with the polarity ，then close the
battery cover .

2）、Connect the GameCube with Televison Set ,put into game

disk,then insert the receiver.

3）Set the switch which is at the back of the controller to “ON”

to turm on the power，POWER LED flash ，then turn on the
power switch of the console，the “CONNECT LED”of the
receiver flash；If then the LED of the controller and receiver
turn flash to shine steadily ，which means the connection
between the controller and receiver is normal and can be
operated normally ；if the LED continue flashing that means
the controller did not connect with the receiver.

4）、Press the key “CONNECT”on receiver ，the flash velocity

speed up ，then press the key“CONNECT”on the
controller until the “CONNECT LED” of the
receiver shine steadily，when the connection between
the controller and receiver is normal.

5）、After connection keeps nornal ,if without pressing any

buttons in 5 minutes，the controller will enter into sleeping

6）、When thecapacity of battery power if too low the POWER

7）、Press any function keys ，then press the key “TURBO”；

8）、When the controlelr’s range beyond the receiving range ,the

saving electricity mode automatically .Just need pressing the
key “CONNECT”of the controlelr when using ,the fuction
will be waken in three seconds ，and the POWER LED shine
then recover the nornal work status .

LED will flash incessantly to remind you changing the fresh
batteries in time.

pressing the key by seted up ,then pressing “TURBO”
again will cancel TURBO function；Press the“TURBO”key，
then press the“START” key again to choose the velocity of
the TURBO，there are four kinds of velocity selection in
all ，once press it will change to another velocity.

key “CONNECT LED” of the reveiver will continue
flashing ,then the controller will not work normally or cannot