2
Product Overview
In order to make sure you get the best possible results from your
new Speaker Band, please thoroughly read and carefully follow all
instructions in this User’s Manual or on the product. Keep this User’s
Manual in a convenient location for future reference.
Package contents:
Speaker Band x 1
Micro USB charging cable x 1
User’s Manual x 1
If any of these were missing or damaged, please visit
bemwirelesss.com to obtain replacement.
Compatibility
All mobile devices enabled with Bluetooth© technology including:
iPhones, iPads, iPods, Smartphones, Laptops, Tablets and more.
Meet the Speaker Band
Before learning your Speaker Band, take a momevnt to look it over
and familiarize yourself with its features.
3
Product Interface
4
1
2
6 7 8
1. Microphone
2. Speaker
3. Volume down
4. Answer / End
< >
3 5
4
5. Volume up
6. Power LED
7. USB
8. Power/Pair button
Getting Started
Pairing with your mobile phone
• Turn on the Speaker Band by press the “Power & Pair” button,
and the LED with lights up with a tone “power on”.
• Hold the “Power & Pair” button for 3 seconds to enter
“pairing mode”, the LED will flash fast with a tone
“pairing mode”.
• Activate Bluetooth on your mobile phone / tablet and select
“Speaker Band”.
• After paired for the first time, the Speaker Band can pair to
your mobile phone automatically when it is powered on.
• To Turn off the Speaker Band hold the “Power & Pair” button
for 3 seconds to enter “pairing mode”, the LED will goes off
with a tone “power off”.
Wear the Speaker Band
Wear the Speaker Band like a watch.
Tips:
Please do not expose your Speaker Band under Rain or high
temperature, such as an oven.
5
Using the Speaker Band
Answer / End Make call
Answer / End Answer call
Answer / End End call
Answer / End Reject call
Answer / End Re-dial last number
Answer / End Play / pause
Answer / End Voice Commands*
< / > Volume down / up Hold < / > button
< / > Play control
*phone dependent
6
Call will automatically transfer
to the speakerphone. If not, tap
Answer/ end button
Tap answer/end button to answer
the incoming call
Tap answer/end button during the
call to end the call
Hold answer/end button to reject
the incoming call
Hold answer/end button to redial
last number when it is not in a call
Tap answer/end button to play
and pause the music play
Double tap answer/end button to
activate the voice command in
your mobile phone
Press < to the last track , press >
to the next track
Caller number
When there is an incoming call, it will speak out the caller’s
number
Charging the Speaker Band
The power LED will flash when the battery is low. Use the supplied
USB cable to charge Speaker Band. Connect the power source
and Speaker Band with the micro USB charging cable, the power
LED will become solid. That indicates that the device is charging.
The Power LED will turn off when it is fully charged.
Trouble Shooting
No connection:
• Make sure the Bluetooth connection of your mobile
phone is on
• Make sure the speaker is on
• Tap the answer/end button to wake up the Speaker Band
• Pair the speaker again
7
Maintenance
Cleaning the Case:
To clean the case, first unplug the power cable. To remove dirt or
dust, wipe the casing with a soft, dry, lint-free cloth. To remove
stubborn dirt or stains, moisten a soft cloth with water and a
neutral detergent and then wipe the casing.
Do not use alcohol, benzene, thinners or other chemical
detergents as these can cause the casing to be warped or
discolored.
Storage
Always power off the Speaker Band when you are finish using it. If
the unit will not be used for an extended period, be sure to follow
these guidelines:
• Do not store the unit in a damp environment
• Avoid exposing the unit to very high or low temperatures
• Avoid prolonged exposure to direct sunlight.
• Charge it before use it again.
8
More Info
For questions, comments or to purchase more be¯m wireless
products go to: bemwireless.com
You can also follow us at:
facebook.com/bemwireless
twitter.com/bemwirelessco
youtube.com/bemwireless
CE2200
For information on your product’s warranty go to:
bemwireless.com/support
FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including
interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
9
FCC Statement (cont.)
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
FCC Radiation Exposure Statement
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
be¯m wireless
http://bemwireless.com/
be¯m wireless LLC.
1725 Kilkenny Ct.
Woodstock, IL. USA
Made in China
10
Product Name : Speaker Band
Model Number :HL2331
Power Supply: USB 5V,1A
Working Temperature: 0˚C-40˚C
Working Humidity: 20%-90%RH
Safety Instructions
This product is specially designed based on the full attention to
safety; in order to make sure the accident-free operation, please
abide the guidelines listed below:
• Always position the unit on a stable and level surface. Unstable surface
can cause the unit to topple and fall, resulting in possible damage or injury
• Do not drop, unpack, open, beat, curve, prink and burn
the unit
• Avoid using the unit nearby basins or sinks where it may come in contact
with water
• Do not place any ware with full water on the top of the unit, such as vase,
glass, pot, and please avoid placing candle on the speaker surface as well
• Protect the using of the unit from any overheating devices (such as
radiator, heating installation, cooking stove or other heating devices)
• Regardless of what reasons cause the unit damage, please ask for the
maintenance personnel to repair
11
Safety Instructions (cont.)
• If you want to do the cleaning, please turn off the unit and
unplug the power cable from the outlet first
• Set the volume properly to prevent injury to the unit and
your personal health
Correct Disposal of this product. This marking indicates that
this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to
the environment or human health from uncontrolled waste
reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
WARNING:
• The battery (battery or batteries or battery pack) shall not be exposed to
excessive heat such as sunshine, fire or the like.
• No naked flame sources, such as lighted candles, should be placed on the
apparatus.
• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type.
12
disposal, recycle it responsibly to promote the sustainable
IC ID STATEMENT
- English: "
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference
that may cause undesired operation of the device."
- French:"
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement."
13
be¯m wireless | 1725 Kilkenny Court | Woodstock IL 60098
TEL: 855-839-8616
2014 be¯m wireless
©
Loading...