Page 1
Battery
The battery of the smartphone is not fully charged.
It is recommended to charge the phone for five hours before
using it for the first time. The full capacity of the battery is
reached after 3-4 complete charge/discharge cycles.
Warranty
The warranty of this product follows the General Conditions
of Delivery and Payment of Pepperl+Fuchs GmbH, which are
available at www.pepperl-fuchs.com, or alternatively they can
be requested directly from the manufacturer.
Support
E-Mail: support@ecom-ex.com
Copyright© 2019 ecom instruments GmbH.
The contents of this document, either in part or in their entirety, may not be reproduced, forwarded, distributed
or saved in any way without ecom instruments GmbH prior written consent.
The contents of this document are presented as they currently exist. ecom instruments GmbH does not provide
any express or tacit guarantee for the correctness or completeness of the contents of this document, including,
but not restricted to, the tacit guarantee of market suitability or tness for a specic purpose unless applicable
laws or court decisions make liability mandatory. ecom instruments GmbH reserves the right to make changes
to this document or to withdraw it any time without prior notice.
Zone 1/21, Div. 1
Zone 2/22, Div.2 rugged
Note:
Please also observe the safety requirements in the specific
safety instructions and the information in the full user guide
for your device.
The documents can be downloaded from the
relevant product page at www.ecom-ex.com
DOCT-6475 | 07/2019
WEEE-Reg.-Nr. DE 934 99306
Subject to change without notice.
ecom instruments GmbH | Industriestraße 2 | 97959 Assamstadt | Germany
Phone +49 62 94 42 24 0 | Fax +49 62 94 42 24 100
sales@ecom-ex.com | www.ecom-ex.com
Intrinsically safe smartphone Smart Ex® 02
QUICK START GUIDE
FOR GLOBAL HAZARDOUS AREAS
Page 2
1
Ear-piece
Alarm key
2
Camera
3
Power key
4
Display screen
5
Camera key
6
Home key
7
Recent apps key
8
9
Charging port
10
Back key
11
Loudspeaker
14
15
12 13
1
2
3
and the battery pack
Step 1
To insert the nano-SIM card
unscrew the two cover screws in
How to insert the nano-SIM card
4
a counter clockwise direction and
remove the battery cover.
Please use the screwdriver Torx T8
provided with the phone.
Step 2
Insert the nano-SIM card with
5
the gold-colored contacts facing
downwards by pushing it upward in
the designated slot.
STEP 2
Step 3
Insert the battery into the battery
STEP 1
6
slot in the prescribed order as
shown in the illustration on the left.
12
Volume keys
13
PTT Key
14
Headset port
15
Proximity/Light sensor
11
10
7
Step 4
Reattach the battery cover
and screw down the two cover
screws in a clockwise direction.
8
Please use the screwdriver Torx
T8 and ensure not to overtighten
9
the screws.
Loading...