Fittings
Parts
(1)Panels x 4pcs (2)Brackets x 6pcs
(A)Drywall Anchors x 12pcs
(B)Screw x 12pcs
1/9
Masterpiece Wall Panel
Assembly Instructions
Tools Required:
A) Phillips Screw Driver and Electric drill in Low Torque mode
B) Tape Measure
C) Level
D) Pencil
E) Hammer
F) Drill bits
2/9
[STEP 1]
Using your measuring tape, find and mark the center point of the surface that you want
your Masterpiece Wall Panels to cover. This is often the center of your wall or bed. Use
your Level to draw a straight vertical line to indicate where you want your panels to
start.
[STEP 2]
Stopper
[STEP 3]
Position your Masterpiece Panels on the floor, backside up. Press and snap one bracket
at a time to the panel with the stopper side down.
once all brackets are connected to your first panel, lift the panel and bracket to position
it against the wall at your mark.
3/9
[STEP 4]
[STEP 5]
With a pencil, mark the where the top holes are to be drilled for the drywall anchors to
be inserted.
With a pencil, mark where the holes are to be drilled for the drywall anchors to be
inserted into the bottom holes.
4/9
[STEP 6]
[STEP 7]
Using an electric drill, drill holes into the wall where the pencil marks have been marked.
Insert the Drywall Anchors into the holes. Tap with a hammer to secure the drywall
anchors.
[STEP 8]
[STEP 9]
Position the brackets on the wall so the holes in the bracket line up with the drywall
anchors in the wall.
Using a Phillips Screwdriver, secure the brackets to the wall by attaching the screws
to the drywall anchors.
Your brackets are now attached to the wall. Before attaching the panels, use a level to
make sure the brackets are level.
5/9
[STEP 10]
6/9
To begin attaching the other two panels. With a pencil, mark where the top holes are to
be drilled for the drywall anchors to be inserted.
Align your second panel above the first panel and snap it into place.
[STEP 11]
7/9
[STEP 12]
[STEP 13]
With a pencil, mark where the holes are to be drilled for the drywall anchors to be
inserted into the bottom holes.
Using an electric drill, drill holes into the wall where the pencil marks have been marked.
8/9
[STEP 14]
[STEP 15]
Insert the Drywall Anchors into the holes. Tap with a hammer to secure the drywall
anchors.
Position the brackets on the wall so the holes in the bracket line up with the drywall
anchors in the wall.
Using a Phillips Screwdriver, secure the brackets to the wall by attaching the screws to
the drywall anchors.
9/9
[STEP 17]
[STEP 16]
Snap the remaining two panels to the brackets. Your Masterpiece Wall Panels are now
installed.
To assemble the Masterpiece Panels Vertically, or to add more panels horizontally,
repeat steps 2 thru 10.
For Customer Support call: 314-993-2693
Loading...