Ecolink Intelligent Technology PIRZ25 User Manual

Motion Sensor with Pet Immunity Installation Instructions

Product Overview

 Z-Wave+TM enabled device which transmits upon detection of movement
 Configurable to be less sensitive to the movement of small and medium size household pets
 Reports tamper condition if cover is removed

Product Specifications

 For indoor use only
 Operating frequency: 908.42 MHz
 Operating range: Up to 100 feet (30.5 meters) line-of-sight
 Operating temperature: 0˚C to 49˚C, 32˚F to 120˚F (ambient temperature)
 Detection radius: 39 feet (see detection region diagram)
 Detection angle: 45 degrees in either direction from the sensor’s center (see detection region diagram)
 Battery type: 3V Lithium CR123A
 Battery life: approximately 3 years
 Passive Infrared (PIR) based technology

Network Inclusion

The sensor must be added to a Z-Wave network prior to use. To include the sensor in a network both the sensor and the network
controller must be in inclusion mode at the same time. Refer to the instructions provided by the manufacturer of your specific controller
for details on initiating the controller’s inclusion mode.

STEP ONE Start by placing the controller into inclusion mode.
STEP TWO Activate inclusion mode for the sensor by removing the battery isolation pull tab, or by inserting the battery (see

next section for battery installation tips). When the inclusion process is complete the red LED will turn on for
approximately 10 seconds and then it will go out. If the LED continues to flash repeat the inclusion process.

STEP THREE Test the motion sensor before mounting it. Place the sensor in an unoccupied room. Leave the room for

at least 4 minutes. Return to the room and pass in front of the sensor lens. The LED will flash once to indicate
that motion was detected.

© 2015 Ecolink Intelligent Technology Inc. PN PIR-ZWAVE2 R1.03

Notes:

 Sensor inclusion mode can also be initiated by inserting a pin or paper clip into the small round hole on the back side of the sensor.
 The sensor also features a test mode so that motion detection can be tested without waiting 4 minutes. For more information refer to the “Test

Mode” section of these instructions.

Network Inclusion: Key Points to Remember

 Controller inclusion mode must be activated BEFORE starting sensor inclusion mode.
 The sensor can only be included into one controller network at a time, and must be excluded from one network before inclusion in another.
 Removing the pull tab connects the battery and initiates sensor inclusion mode. Inclusion mode can also be initiated by removing the battery for at least 5 seconds,

reinstalling the battery, then replacing the sensor cover.

 The plastic pull tab must be removed to enable sensor operation.
 The sensor automatically enters inclusion mode at power-up.

 Exclusion mode on the senor is initiated following the same exact procedure as inclusion.

Battery Installation Tips

Installation

The package contains the following:

© 2015 Ecolink Intelligent Technology Inc. PN PIR-ZWAVE2 R1.03

Bracket

Screws

(Optional)

Once the mounting bracket is in place, align the holes on the
back of the motion detector with the key on the bracket. Slide the
sensor down on the keys until it snaps tight.

1x Sensor
1x Sensor mounting bracket
4x screws
2x jumper
1x battery
3x pieces of adhesive tape

STEP ONE Mount bracket to wall

First attach the sensor mounting bracket to the wall using either adhesive tape OR screws (optional). For best performance mount
the bracket 6.5 to 7.5 feet above the floor (2 to 2.3 meters).

Adhesive

Corner Mount Flush Mount

Note: For best results, attach adhesive tape to bracket FIRST, then position on wall. Adhesive tape is VERY STRONG so moving the bracket after attaching will be

difficult.

STEP TWO Attach Motion Detector to Bracket

© 2015 Ecolink Intelligent Technology Inc. PN PIR-ZWAVE2 R1.03