A Universal Electronics Company
Z-Wave Plus Smart Switch
Dual Toggle
Installation Guide
© 2018 Ecolink Intelligent Technology Inc. PN DTLS2-ZWAVE5
Product Overview
Easily automate overhead lights, table lamps or other accessories with the
Ecolink Z-Wave Plus Smart Switch. Simple to install in minutes by removing
existing switch plate and installing this on the switch. No need to touch any
electrical wiring.
Features
Quick installation, no need to access high voltage wires
Compatible with all Z-wave certified hubs & controllers
Preserves manual control of switch
Senses current status of switch
Works with dual gang toggle type switches
Specifications
For indoor use only
Operating frequency: 908.42, 916 MHz
Operating temperature: 0° – 49°C, 32° – 120°F (ambient
temperature)
Operating humidity 5-95% non-condensing
2 AA batteries per unit
Battery Life: 1 year
Package contents
2 x Z-Wave Plus Smart Switch (Dual Toggle)
4 x AA batteries
1 x Installation Guide
Installation Instructions
(1) Identify location for Z-Wave Plus Smart Switch.
(2) Remove the switch plate cover of the existing dual light switch. Save
the screws for next step.
(3) Remove the switch plate cover of the Z-Wave Plus Smart Switch
with the help of a flat head screw driver.
(4) Install the first smart switch on the left existing switch using screws
from step two. It should be oriented such that the batteries are on
the left side. Next, install the second smart switch on the right
existing switch using screws from step two. It should be oriented
such that the batteries are on the right side.
(5) Install 4x AA batteries provided in the package.
(6) Follow the Network Inclusion steps in next section.
(7) If the switch operates in an inverted state during Z-wave operation
i.e. turns ON instead of OFF and OFF instead of ON, toggle the
position of the orientation switch (red rectangle) to fix this
behavior.
(8) Snap the cover back onto the Z-Wave Plus Smart Switch in the
correct orientation.
© 2018 Ecolink Intelligent Technology Inc. PN DTLS2-ZWAVE5