Ecolink Intelligent Technology BHAWT001 User Manual

1523 26th St.
Santa Monica, CA 90404

Supplier’s Declaration of Conformity –
Compliance Information Statement

Unique Identifier:
Ring Retrofit Alarm Kit

Responsible Party and Party issuing Supplier’s
Declaration of Conformity

Ring LLC dba Ring
1523 26th Street
Santa Monica, CA 90404
U.S.A.
www.ring.com / [e-mail]

FCC Compliance Statement (for products
subject to Part 15)

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.

NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed

and used in accordance with the instructions,
may cause harmful interference to radio
communications.

However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment o and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the

equipment and receiver.
Connect the equipment into an outlet on a

circuit dierent from that to which the receiver
is connected.

Consult the dealer or an experienced radio/
TV technician for help.

Innovation, Science and Economic
Development Canada (ISED) Compliance

This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada’s licence-exempt
RSS(s). Operation is subject to the following
two conditions:

This device may not cause interference.
This device must accept any interference,

including interference that may cause
undesired operation of the device.

Conformité Innovation Sciences et
Développement Économique Canada
(ISDE)

L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences
et Développement économique Canada
applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux
conditions suivantes:

L’appareil ne doit pas produire de brouillage.
L’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le
fonctionnement.

CAN ICES-3 (B)/NMB-3(B)

AVERTISSEMENT : Tout changement ou
modification à cet appareil qui n’a pas fait
l’objet d’une autorisation expresse par la
partie responsable de sa conformité pourrait
annuler le droit pour l’utilisateur d’opérer
l’équipement.

CAUTION: To reduce the risk of electrical
shock, DO NOT open the unit. There are no
user serviceable parts inside the unit. Refer to
customer support for any repairs.

ATTENTION : Pour réduire le risque
d’électrocution, NE PAS ouvrir l’appareil.
Aucune pièce interne n’est réparable par
l’utilisateur. Veuillez vous référer au service à la
clientèle pour toute réparation.

In accordance with FCC requirements of
human exposure to radio frequency fields,
the radiating element shall be installed such
that a minimum separation distance of 20 cm
is maintained from the general population.

Conformément aux exigences d’Industrie
Canada en matière d’exposition humaine
aux champs de radiofréquences, l’élément
rayonnant doit être installé de telle sorte
qu’une distance minimale de 20 cm soit
maintenue par rapport à la population
générale.

WARNING: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user’s authority to operate the equipment.

CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type recommended
by the manufacturer. Dispose of the used
batteries according to the manufacturer’s
instructions.

ATTENTION : Danger d’explosion si la
pile n’est pas remplacée correctement.
Remplacez la pile uniquement par une pile
identique ou par une pile du même type que
celle recommandée par le fabricant. Suivez
les instructions du fabricant pour jeter les
piles usées.