Ecolink Intelligent Technology 1032R01 User Manual

Ecolink Boomerang
Model#: BOOM433
Bridge and Wireless Gateway Instruction Manual

Ecolink Bridge (Model#: BOOM433) - this is the main control units for this system. It must be located in

the same room but not more than 50ft of your Zwave gateway.

Status Module (Model#: STAT433) - this device provides the current status of the sensor installed on
your doors and windows. This should be located at your main entry/exit door (to check status as your
leave) or by your bedroom (to check status before you go to bed at night)

Door/Window sensor(Model#: DOOR433) - these are the sensors that you will mount on your doors
and windows. It will transmit back to the unit if the door/window is opened or closed.

Setup

The suggested process for configuring your system is as follows.

1. Power up the bridge

2. Enroll your door/window sensors

3. Enroll the status module

4. Install your door/window sensors

5. Test your system

6. Mount your status module

7. Include your Insynctive network into a Zwave gateway (optional)

Power up the bridge

Your Ecolink Bridge comes ready to plug into any standard electrical outlet.
However there are a number of jumpers located in the battery compartment that control the door
chime feature. You may want to adjust this prior to plugging it in as they are not accessible after you do
so.

The jumper options are as follows:

Volume Chime

J1 J2 J3 J4 Operation
off off X X Volume controlled by Z-wave GUI
off on X X Low volume
on off X X Med volume

on on X X High volume (default)

X X off off No chime
X X off on Chime when door or window is opened
X X on off Chime when door or window is unlocked

X X on on Chime when door or window is opened or unlocked (default)

The first time you plug in your bridge, the light will turn green, then start flashing blue.

Enroll Door/window sensors

Unpack your sensors, including the magnet.
Slide the top cover to disengage it from the bottom.
Remove the top cover to reveal the battery.
Remove the plastic tab that is installed underneath the battery.
Ensure the battery is firmly in place.

At this point you can decide to replace the white cover or switch to the brown cover. The brown cover,
when installed, will cover the bottom piece so only brown is visible after installation.

After you power up the sensor, you have approximately 2 minutes to enroll the sensor into the bridge.
If more than 2 minutes has elapsed, just remove the battery and
reinstall to get another 2 minute window.

To start the learn process, you must press the learn button on the bridge.
This is the bottom button located on the side of the bridge

When you press this, the bridge will start to flash orange.

To trigger a learn command from the sensor,
touch the magnet to the sensor three times
within 2 seconds.

If successful the bridge will flash green and beep once for 2sec.

At this point it is recommended to record the sequence in which sensors were enrolled and where this
sensor will be mounted. This will prove useful when including your system into a Zwave network.

Repeat this step until all your sensors have been enrolled into the bridge.

When you are done, press the learn button again to exit this mode.

As you move the magnet back and forth within range of the sensor bridge will beep. This is the chime
feature and is useful to determine when someone opens a door or window within the home. It also
confirms the sensor was properly enrolled.

Enroll Status Module

Unpack the status module and insert the 2 AA batteries.
Do not put the battery cover back on.

Press the learn button on the bridge to activate the learn mode.
The bridge will start to flash orange.

Press the button on the status module that is located underneath the battery
compartment