Ecofit GTY110 Warranty And Quick Start Manual

ECOFIT Gateway

Warranty and Quick Start Guide

Model: GTY110

Rev: 1.1

Gateway

001-256-55801

ECOFIT Networks Inc

Contents

Contents............................................................................................. 1

Networking Considerations ........................................................... 2

Gateway Installation........................................................................ 3

Gateway Mounting........................................................................... 4

User Notice ...................................................................................... 6

Warranty Statement ...................................................................... 7

Certification Information............................................................... 8

Network Considerations

The ECOFIT Gateway is designed to connect over a DHCP connection.

If the facility implements network security, supply the following information to their
IT personnel:

UPDATE CHANNEL

REMOTE ACCESS

SESSION SUBMIT CHANNEL

HTTPS Port 443, MAC Authorized, Outgoing

TCP Port 4040, Outgoing

HTTPS Port 443, REST, Basic Authorization, Outgoing

If required, a static IP address can be set on the Gateway.
This is done by logging into the Gateway and manually setting the IP address in the

Network Settings.

Full step by step instructions can be found on the ECOFIT Help Center.

DHCP

STATIC IP

Gateway Installation

The Gateway package contains the following:
1 - Gateway PC 1 - Gateway Power Supply

1 - Gateway Wall Mounting Kit 1 - Power Cord

1 - Ethernet Cable 1 - Antennas

1. Connect both antennas to Gateway.

2. Connect active ethernet port.

Gateway - Back

Gateway - Back

3. Connect to power supply to active

outlet.

4. Gateway will automatically power up.

Visit the ECOFIT Help Center for configuration information.

02-004-8F8T

Gateway - Front

Gateway - Back

Gateway Mounting

To Wall Mount the System:

1. Locate the 2 screw holes

reserved for mounting on the
bottom of the Gateway PC

2. Place the mounting panel on
the Gateway. Fasten compatible

screws to secure the Gateway.

3. Screw the mounting pad to the
wall using the above marked screw
holes. Ensure the screws are fixed

securely to the wall.

Gateway Mounting

To VESA Mount the System:

1. Locate the 2 screw holes

reserved for mounting on the
bottom of the Gateway PC

2. Place the mounting panel on
the Gateway. Fasten compatible

screws to secure the Gateway.

3. Remove the reserved screws

for VESA mount on the back

cover on the monitor/TV.

4. Screw the mounting pad to the
back of the monitor/TV. Ensure the
screws are fixed securely.

User Notice

COPYRIGHT OF THIS MANUAL BELONGS TO THE MANUFACTURER. NO PART OF THIS MANUAL INCLUDING THE PRODUCTS AND SOFTWARE

DESCRIBED IN IT MAY BE REPRODUCED, TRANSMITTED OR TRANSLATED INTO ANY LANGUAGE IN ANY FORM OR BY ANY MEANS WITHOUT WRITTEN

PERMISSION OF THE MANUFACTURER.

THIS MANUAL CONTAINS BASIC INFORMATION REQUIRED TO INSTALL THE GATEWAY PRODUCT. WE ASSURE THAT THIS MANUAL MEETS THE
USER’S REQUIREMENT BUT MAY BE CHANGED OR CORRECTED AT ANY TIME WITHOUT NOTICE. MANUFACTURER PROVIDES THIS MANUAL “AS IS”

WITHOUT A WARRANTY OF ANY KIND, AND WILL NOT BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES
(INCLUDING DAMAGES FOR LOSS OF PROFIT, LOSS OF BUSINESS, LOSS OF DATA, INTERRUPTION OF BUSINESS ETC.).

PRODUCTS AND CORPORATE NAMES APPEARING IN THIS MANUAL MAY OR MAY NOT BE REGISTERED TRADEMARKS OR COPYRIGHTS OF THEIR

RESPECTIVE COMPANIES, AND THEY ARE USED ONLY FOR IDENTIFICATION OR EXPLANATION AND TO THE OWNER’S BENEFIT, WITHOUT INTENT TO

INFRINGE.

Manual Revision Information

Revision Revision History Date

1.0

First Edition August 8, 2016

1.1

Brand Edits

May 02, 2018

Environmental Safety Instruction

Avoid dust, humidity and temperature extremes.

Do not place the product in any area where it may become wet.

0-40 Centigrade is the optimal operating temperature.

Warranty Statement

Reputable Warranty

ECOFIT strives to provide the highest quality products to our customers. In keeping with that goal, we provide the most dependable warranty in the
industry, where all of our products are backed by a 3-year limited warranty from the date of manufacture.
All warranties are handled directly through ECOFIT Networks. End users must contact ECOFIT directly to obtain warranty. To determine if a product is
within the 3-year limited warranty, contact support@myecofit.com.

3 Year Limited Warranty

Limited Warranty The liability of ECOFIT under this warranty is limited. The Purchaser, by taking receipt of any ECOFIT product (“Product”), acknowledges
the terms of the Limited Warranty in effect at the time of such Product sale and acknowledges that it has read and understands same.

The ECOFIT Limited Warranty to the Purchaser on the Products sold hereunder is a manufacturer’s pass-through warranty which the Purchaser is
authorized to pass through to its customers. Under the Limited Warranty, each ECOFIT Product is warranted against defects in workmanship and
materials if the Product is installed and used in compliance with ECOFIT’s instructions, ordinary wear and tear accepted. The pass-through warranty
period is for a period of thirty-six (36) months from the date of purchase if the Product is not installed during that period, or twelve (12) months from
the documented date of installation if installed within twenty-four (24) months from the original purchase date.

The liability of ECOFIT under the Limited Warranty shall be limited to, at ECOFIT’s sole discretion: the cost of parts and labor provided by ECOFIT to
repair defects in materials and / or workmanship of the defective product; or to the exchange of the defective product for a warranty replacement
product; or to the granting of credit limited to the original cost of the defective product, and such repair, exchange or credit shall be the sole remedy
available from ECOFIT, and, without limiting the foregoing in any way, ECOFIT is not responsible, in contract, tort or strict product liability, for any other
losses, costs, expenses, inconveniences, or damages, whether direct, indirect, special, secondary, incidental or consequential, arising from ownership or
use of the product, or from defects in workmanship or materials, including any liability for fundamental breach of contract.

The pass-through Limited Warranty applies only to those defective Products returned to ECOFIT during the warranty period. This Limited Warranty does
not cover the cost of the parts or labor to remove or transport the defective Product nor does it cover the cost to transport and reinstall the repaired or
replacement Product, all such costs and expenses being subject to Purchaser’s agreement and warranty with its customers.

Any representations or warranties about the Products made by Purchaser to its customers which are different from or in excess of the ECOFIT Limited
Warranty are the Purchaser’s sole responsibility and obligation. Purchaser shall indemnify and hold ECOFIT harmless from and against any and all
claims, liabilities and damages of any kind or nature which arise out of or are related to any such representations or warranties by Purchaser to its

customers.

The pass-through Limited Warranty does not apply if the returned Product has been damaged by negligence by persons other than ECOFIT, accident,
fire, Act of God, abuse or misuse; or has been damaged by modifications, alterations or attachments made subsequent to purchase which have not been
authorized by ECOFIT; or if the Product was not installed in compliance with ECOFIT’s instructions; or if due to defective installation of the Product; or if
the Product was not used in compliance with ECOFIT’s instructions.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, WHICH THE GOVERNING LAW ALLOWS PARTIES TO CONTRACTUALLY
EXCLUDE, INCLUDING, WITHOUT LIMITATION, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, DURABILITY OR
DESCRIPTION OF THE PRODUCT, ITS NON-INFRINGEMENT OF ANY RELEVANT PATENTS OR TRADEMARKS, AND ITS COMPLIANCE WITH OR NON-VIOLATION
OF ANY APPLICABLE ENVIRONMENTAL, HEALTH OR SAFETY LEGISLATION; THE TERM OF ANY OTHER WARRANTY NOT HEREBY CONTRACTUALLY
EXCLUDED IS LIMITED SUCH THAT IT SHALL NOT EXTEND BEYOND TWENTY-FOUR (24) MONTHS FROM THE PRODUCTION DATE, TO THE EXTENT THAT

SUCH LIMITATION IS ALLOWED BY THE GOVERNING LAW.

Product Warranty Return Procedure All Products that are believed to have defects in workmanship or materials must be returned, together with a
written description of the defect and a Return to Manufacturer Number (RMA) to ECOFIT. An RMA can be obtained by contacting support@myecofit.com

Check out our online Help Center for more information.

myecofit.zendesk.com

EM - support@myecofit.com
TF - 1.855.380.0123

Do not dispose of this electronic device into the trash.
To minimize pollution and ensure environmental protection, please recycle.

IC: 12408A-GTY110
CAN ICES-3 (B)/NMB-3(B)

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.

FCC ID: 2ADCN-GTY110

The minimum distance where the maximum permissible exposure limit is reached is 3.01 cm from the GTY110

with the 2dBi antenna.

It is recommended that the unit is positioned so that the typical distance from the antenna to the end user is

20cm or greater.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY

UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.

This Class B digital apparatus complies with Canadian ICES-003 and RSS-247.
This device complies with Industry Canada license-exempt RSS standard(s).

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.

Canada, Industry Canada (IC)