Eclipse Eclipse SS-989E Manual

SS-989
2 IN 1 SMD HOT AIR REWORK STATION
User’s Manual
1st Edition, 2015 ©2015 Copyright by Prokit’s Industries Co., Ltd.
Test Equipment Depot - 800.517.8431
99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
1
Thank you for purchasing Pro’sKit product. The SS-989 2in1 SMD Hot Air Rework Station has been designed to meet high quality standards. Please properly use and care of your product for prolonging service life.
For the complete user manual downloading,
SAFETY INSTRUCTIONS
WARNING Warnings and cautions are placed at critical points in this manual to direct the operator's attention to significant items. They are defined as follows:
WARNING: Failure to comply with a WARNING may result in serious injury
or death.
CAUTION: Failure to comply with a CAUTION may result in injury to the
operator, or damage to the items involved. Two examples are given below.
NOTE : A NOTE indicates a procedure or point that is important to the process
being describe.
EXAMPLE : AN EXAMPLE is given to demonstrate a particular procedure, point
or process.
_ Be sure to comply with following WARNINGS and CAUTIONS for your
safety.
WARNING
_ Be sure not to operate the unit with any combination of temperature and air
flow settings that makes the thermal protector trip (the heater lamp turns off during use). This could damage the unit.
CAUTION
When the power is ON, the temperature of the hot air and the nozzle ranges from indoor temperature to 480°C ( 896°F). To avoid injury to personnel or damage to items in the work area, observe the following:
_ Do not direct the hot air toward personnel or touch the metal parts near the
nozzle. _ Do not use the product near combustible gases or flammable materials. _ Advise those in the work area that the unit can reach very high temperatures
and should be considered potentially dangerous. _ Turn the power OFF when no longer using the Pro’sKit SS-989 or when
leaving it unattended. _ Before replacing parts or storing the unit, allow the unit to cool and then turn
the power OFF.
To prevent accidents and failures, be sure to take the following precautions:
2
_ Do not strike the hand piece against hard surfaces or otherwise subject it to
SMD rework temperature display
Soldering temperature display
SMD rework
power switch
Soldering iron temperature regulation knob
SMD rework temperature
regulation knob
Air flow adjustment knob
Socket of soldering iron SMD rework temperature calibration
Soldering temperature calibration
Soldering power switch
physical shock. _ Be sure the unit is grounded. Always connect power to a grounded receptacle. _ Do not disassemble the pump. _ Do not modify the unit. _ Use only genuine Pro’sKit replacement parts. _ Do not wet the unit or use the unit with wet hands. _ Remove power cord by holding the plug – not the wires. _ Make sure the work area is well ventilated. _The Pro’sKit SS-989 is not intended for use by children or infirm persons
without supervision. _ Children should be supervised to ensure that they do not play with the SS-989.
I. Packing list and name of parts
Name of Parts
Packing List
1. 1.SS-989 2 in 1 SMD Hot Air Rework Station
2. User’s manual
3. Soldering iron
4. Soldering iron Stand
5. Heat Gun holder
6. Air nozzle x 3
Loading...
+ 7 hidden pages