Echomaster CAM-TGL User Manual

Download

Page 1

Back-up Camera

with Moving Guidelines

User Manual

CAM-TGL

Page 2

Installation Guide

Thank you for purchasing the EchoMaster Back-up Camera with Moving Guidelines

EchoMaster Cameras are designed to improve safety by providing high quality images of surrounding areas and obstacles in the vicinity of the vehicle. This may help improve vehicle maneuvering capabilities by displaying blind spots or areas not normally visible to the driver.

Please ensure you read and understand all aspects of this manual before installing or using your EchoMaster products.

PLEASE NOTE

Before use, remove plastic cover on the camera lens

Page 3

Installation Guide

email - [email protected]

tel - 800-477-2267

What’s Included:

uCamera uLicense Plate Bracket uInstallation Hardware uWiring Harness (39”) uRCA Cable (20’) uUser Manual

Features:

u1/3” CMOS sensor uOperates at 0.5 LUX u170° viewing angle uDynamic parking guidelines uWater/Debris-proof rating: IP67

Page 4

Installation Guide

Out of the Box: License Plate Bracket

The license plate bracket is mounted to the camera when you take it out of the box.

To Use Lip Mount Bracket:

Follow these steps to replace the License Plate Bracket with the Lip Mount Bracket.

Step 1

Remove the screws on each side of the camera to remove the license plate bracket.

-Screwdriver not included

Page 5

Installation Guide

email - [email protected]

tel - 800-477-2267

Step 2

Out of the Box: Lip Mount Bracket

Unscrew the screws on each side of the lip mount bracket.

-Be careful to not lose the lock washers!

Step 3

Align the brackets and replace the screws and lock washers.

Lip Mount Bracket is Now Ready for Install

The camera is now ready to mount to the vehicle’s lip.

-Screws and adhesive provided

Page 6

Installation Guide

Installing the Camera

- License Plate Mount

Step 1

Remove the screws that hold the license plate to the vehicle and remove the license plate.

Step 2

Find an opening (or drill a small hole) to feed the camera cable into the vehicle.

Page 7

Installation Guide

email - [email protected]

tel - 800-477-2267

Page 8

Installation Guide

Step 3

Position the camera mounting bracket behind the license plate. Insert the screws to hold the camera and license plate in place.

Step 4

The camera angle should be mounted at 30 - 40 degrees downward for dynamic guidelines to perform correctly.

Step 5

Connect to the monitor. (see instructions on page 12)

Page 9

Installation Guide

email - [email protected]

tel - 800-477-2267

Page 10

Installation Guide

Installing the Camera

- Lip Mount

Step 1

Find an opening (or drill a small hole) to feed the camera cable into the vehicle.

Step 2

Position the camera mounting bracket on vehicle lip and screw into place.

Step 3

The camera angle should be mounted at 30 - 40 degrees downward for dynamic guidelines to perform correctly.

Step 4

Connect to the monitor. (see instructions on page 12)

Page 11

Installation Guide

email - [email protected]

tel - 800-477-2267

Mounts to vehicle lip

Page 12

Installation Guide

For both License Plate and Lip Mount

Connect to Monitor

Use harness and RCA cable to connect the camera to your monitor with a standard video input.

(533mm/21in)

Page 13

Installation Guide

email - [email protected]

tel - 800-477-2267

Compatible with aftermarket radios, factory radios, and rearview mirror monitors.

GND (Black)

(990mm/39in)

+12V (Red)

(6m/20ft)

VIDEO

Page 14

Installation Guide

Installer Notes

Some vehicles’ reverse lamp wires are now variable voltage wires, and may cause a fuzzy or distorted image. If you experience this, please use a relay to power your camera, as shown in the diagram.

Page 15