Page 1
pp
OASIS
Table Trough Installation Sheet
Oasis Oasis Mini
Cutout 8.25 8.25
Width*
Cutout 29.12 14.12
Length
* See Cutout Detail for undercuts
required for door clearance.
Cutout
Width *
CUTOUT SIZES
FIGURE 1
TM
& OASISTM MINI
Clamp & Thumb Screws
2 Sets
Thumb Nut & Washer
2 Per Insert
Cutout
Length
Double Sided Adhesive Tape
Not Su
lied
FIGURE 2
Removable
Inserts
ECA • 10 Mountain View Drive • Shelton, CT 06484 • Phone: 1-800-521-3175 • Fax: 203-924-6687
9065-0099 Rev H
Innovati ve Power + Data Solutions
www.electri-cable.com
OASISTM Pan
Page 1 of 3
Page 2
CUTOUT DETAIL
.50
Both
Sides
Door Swing
Keyslots Engaged
Over T-Studs
Outer Pan
(Optional)
Thumb
Cutout Width *
9.00 Clearance
11.20 Outer Pan Width
Table
Thickness
1.25 – 2.00
Corded = 4.90
Sys 42 = 5.85
5.28
Outer Pan
Depth
Installation Instructions
1. Cutout table as required (see Figure 1, Cutout Sizes & Cutout Detail)
2. Insert OASIS
Screws provided. Note: Keyslots in clamps engage over T-Studs in OASIS™ and th umb
screws tighten against underside of table surface. (double sided tape may be required
to prevent side of Bezel from bowing when in table).
3. Check for smooth operation of doors and adjust in cutout if required.
4. OASIS
desired. To reposition OASIS
reposition as needed (see Figure 2).
5. Connect all power & data cabling as needed and check for proper operation.
6. Attach Outer Pan (optional) to underside of table as shown in Cutout Detail.
ECA • 10 Mountain View Drive • Shelton, CT 06484 • Phone: 1-800-521-3175 • Fax: 203-924-6687
TM
TM
into cutout from above and clamp into position using Clamps & thumb
Inserts have been installed at the factory but may be repositioned in the field if
TM
Inserts remove thumb nuts & washers from rear and
Innovati ve Power + Data Solutions
www.electri-cable.com
9065-0099 Rev H
Page 2 of 3
Page 3
ECA • 10 Mountain View Drive • Shelton, CT 06484 • Phone: 1-800-521-3175 • Fax: 203-924-6687
Innovati ve Power + Data Solutions
www.electri-cable.com
9065-0099 Rev H
Page 3 of 3
Loading...