E BRIDGE OPTOELECTRONICS SLIMBOX070272 User Manual

Slim A/V MODULE Connection instructional diagram

1

2

3

Equipment Name: SLIM A/V MODULE

A Division of TMI Products , Inc. Model:07-0272-000

Explanation：

1. Connects the power source (BLACK：GROUND / GREEN：

PARKING / YELLOW：+12 BATT /RED：ACC)。

2. Connection monitor / INPUT AV

3. two groups output AV

4. Connection Antenna

1493 Bentley Drive.Corona,CA 92879 *951-272-1996*800-624-7960*Fax [phone]

www. Vizualogic .com

4

FM

FCC Statement

To

listen to the audio por
stereo system aim the remote at the driver’s side monitor and simply press the for classsB digital device, pursnant to part to part 15 of the FCC Rules.
FM

SOURCE button to turn the FM

Modulator Playback

tion of the vie

wed source though the vehicle’s

modulator on.

The screen will now

This equipment has been tested and found to comply with the limits

display These limits are designed to provide reasonable protection against harmful
FM SOURCE: DRIVER
the Driver's side headrest will now be
different audible source is desired, press the FM
from PASSENGER
has been selected, the transmitting frequency
can be changed by pressing the FM FREQ
cle’s radio to the corresponding station to listen to the source that is displayed
on the driver’s side monitor

Increase the separation between the equipment and receiver.

To

change the transmitting frequency,
monitor and press the FM FREQ
frequency as

FM CH1 8

89.1M

subject to the following two conditions:

8.5M

Hz　FM CH5 8

DVD. The Audio por

DVD, EXT AUX,

follows: Consult the dealer or an experienccd radio/TV technician for help.

Hz　FM CH2 8

9.3M

and OFF. Once the desired audible source

. Reorient or relocate the receiving antenna.

button. Each press of the button advances the the receiver is connected.

8.7M

Hz　FM CH3 8

Hz　FM CH6 8

tion of the source originating from

audible through the vehicle's stereo. If a

SOURCE button again to select energy and, if not installed and used in accordance with the instructions, may

the FM

modulator transmits on

button on the remote. T

aim the remote at the driver’s side Connect the equipment into an outlet on a circuit different from that to which

8.9M

Hz　FM CH

9.5　FM CH7 8

9.7　FM8 89.9

une the vehi

4

- determined by tuming the equipment off and on, the user is encouraged to try to correct

the

interference in a residential installation.

This equipment generates,uses and can radiate radio frequency

cause harmful interference to radio communica-tions.however, there is no

guarantee that interference to radio or televison reception, which can be

interference by one of the following me asures:

This device complies with Part 15 of the FCC Rules.Operation is.

To

turn the FM

press the FM

NOTE:

All of the FM

similar fashion using the buttons on the front of the monitor.

Modulator Off aim the remote at the driver’s side monitor and (1)

SOURCE button repeatedly until FM OFF is displayed. (2)

Modulator control functions can also be controlled in a

This device may not cause harmful interference, and

This device must accept any interference received, including

interference that may cause undesired operation