Page 1
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENTI！COUPER LE COURANT AUNIVEAU DE FUSIBLES OU DU DISJONCTEUR
PREPARATION
1. Shut off the power at the circuit breaker box
(avertissement! couper le courant au niveau des
fusibles ou du disjoncteur) and remove the old
fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3. Secure mounting back plate (A) to the junction box
using mounting screws (B)(Size:8-32*1/2”L).
The side of the mounting back plate marked “GND”
must face out.
CONNECTING THE WIRES (FIG. 2)
4. At this point, connect the electrical wire as shown in
Fig. 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or
bare copper), connect the fixtures ground wire to it.
Otherwise, connect the fixture ground wire directly to
the back plate (A) using the green screw provided.
After wires are connected, tuck them carefully inside
the junction box.
5. Place the fixture’s back plate (C) over the mounting
back plate (A) and secure with screws (D).
FINISHING THE INSTALLATION (FIG.1)
6. Install the Xenon G9 bulbs for your fixture (3 ×
Max 60W). DO NOT EXCEED THE
SPECIFIED WATTAGE! （NE PAS
DEPASSER LA PUISSANCE
NOMINALE MAXIMALE）
7. Slide the glass (H) into the front bracket (E) and
secure the shield (F) to the front bracket with screws
(G).
Return power to the junction box and test the fixture.
Your installation is now complete.
IMPORTANT INSTRUCTION:
1. The light bulb gets HOT Quickly! Allow the light bulb to
cool for 10 minutes before handling the bulbs and
glass. Take out the glass from the fixture as show in
Fig.1 (Step1.screw the screws (G) out and remove
the shield (F) Step2.pull the glass up till the other
side of it to place I. Step 3. take the glass out from
the fixture).
IMPORTANT: Fixture should be installed by a
qualified electrician to ensure proper wiring and
H
Mounting screw(2)
Ground screw
Mounting Back Plate
Ground
wire
Fig.1
INSTALLATION INSTRUCTIONS
For Wall Mount Fixture
Loading...