INSTRUCTION
MANUAL
ASSEMBLY GUIDE
Co
ngratulations, you are now the owner of a chair!
To best enjoy the comfort of the chair, you have to put it together first! This assembly
guide will take you through the assembly process. To make sure the assembly goes
well, please follow the instructions, and especially the important safety information.
It is possible to assemble the chair on your own, but it is recommended to have
a second person to make it easier and safer.
Please check if there are any missing parts from the package before starting. If there
is any issue, please don't hesitate to drop us an email and we'll help you out ASAP.
If you run into any difficulty when assembling the chair, remember to check out the
assembly video to see if you've missed anything. If you're unable to resolve the problem,
just send us an email and our support team will assist you.
WARNING
To ensure proper assembly, please follow all steps and use all parts. Failure to
follow this warning can result in serious injury to yourself or others.
2
Package List
Without further ado, we kindly suggest you to list all parts needed
for the chair first.
(A)*1 (B)*1 (C)*1
Back
Cushion
(D)*5 (E)*5 (F)*10
Legs
(G)*1
Wrench
Gas Lift
Casters Bolts
Base
3
Assembly Instruction
Step 1:
Connect the leg (D) and base (C)
with the bolts (F), tighten the bolts
with Wrench (G).
Press the Casters (E) into the holes
at the end of each Leg (D).
Tips:
Don’t make the caster go vertical
to the hole, it will be easy for
installation if make it
has a little angle.
2
(D)
(B)
1
(13)×2
(C)
Step 2:
And then insert the Gas Lift (B)
into the center hole of the Base.
(E)
4
Step 3:
Insert the Back Cushion (A) into
the slot on the back of Mechanism.
4
3
Step 4:
Finish the installation
5
5
Instructions For Use
1. Seat Height: Paddle-shaped lever on the right side
To raise:
While taking your weight off chair,
lift lever up.
To lower:
While seated, lift lever up.
* At the proper height, your feet should rest flat on the floor.
7
6
Safety And Maintenance
Do not stand on the chair, Do not use the chair as a stepladder.
Use this product for seating one person at a time.
Do not use the chair unless all bolts and screws are firmly secured.
Avoid contact with sharp objects to prevent puncturing the fabric.
Every 6 months, check all bolts and screws to ensure they are tight.
To clean, spot clean only using a damp towel and mild cleaner, first
test on a small, unseen area of fabric.
Chair weight limit not to exceed 250 lbs.
Safety Information
Sit in the center of the
chair, with your back to
the backrest
Do not push the chair
around when a person
is sitting in it
Do not sit at the front
edge of the chair
Do not push down on
the backrest when a
person is reclined
Do not stand on the
chair
Do not place all your
weight on only the
Do not use the chair
with more than one
backrest
person
9
7
Limited Warranty
The producer promises to repair or replace any chair that is found to be
defective in material or workmanship within one(1) and year from the date
of original purchase so long as you, the original purchaser, still owns it.
This is your sole and exclusive remedy. This warranty is subject to the
provisions below.
EXCLUSIONS:
This warranty does not apply and no other warranty applies to:
Normal wear and tear, which are to be expected over the course of
ownership.
Misuse, abuse, or excessive use of the product.
Modifications or attachments to the product that are not approved
by the manufacturer.
Products that were not installed, used or maintained in accordance
with product instructions and warnings.
Products used for rental or commercial purposes.
Damage caused by the carrier in-transit is handled under separate terms.
SEATING USAGE:
Normal use for seating is identified as the equivalent of a single shift,
forty- (40) hour workweek. To the extent that a seating product is used
in a manner exceeding this, the applicable warranty period will be
reduced in a pro-rata manner.
Some retailers might have custom models imported directly from the
factory and therefore are not supported by our local service team
because we don’t have the correct parts, please contact your retailer
directly for support. If you have any questions about that we will be
happy to assist and identify those items.
10
8
Loading...