Page 1
-1-
ASSEMBLY INSTRUCTIONS
Pantry Cabinet
Page 2
Unpacking Precautions
Wall Cabinet Model Variations
Required Tools
Phillips Screwdriver
Rubber Mallet
Wood Glue
Hardware Considerations/Screw Size Clarification
(I) Small 1/2''
(K) Large 1 1/4''
(M) Larger 2 3/8''(Optional)
Lay the face frame with doors(A) on a soft surface, doors facing down.
Step 1
Step 2
-2-
If using a sharp object to unpack the cabinet components and the packing materials, be careful to avoid
scratching or damaging the cabinet components. The various packing materials may be used to protect the
cabinet components during assembly. During the unpacking process, place the various components away
from and to the side of the work area so that they will not be inadvertently knocked over or otherwise
damaged.
These assembly instructions include all the steps required to assemble a Wall Cabinet with or without a
Shelf/Shelves.
：
A
Attached rubber bumpers to both the top and bottom of each door where
they make contact with the face frame to prevent damage and reduce noise.
Page 3
Step 3
Step 4
Step 5
Step 6
-3-
Using the wood glue, squeeze a small bead of glue in all grooves before
assembling the cabinet sides, bottom, top and back panels. Be careful not to
panels, if this should happen, be sure to remove quickly.
Slide the left and right side panels into the grooves of the face frame, and
is fully seated.
side. Each male clip will need 2 small screws(I).
Left
T
M
B
use too much glue, this could cause access glue to squeeze out and onto the
mount the male clip to the face frame with a screwdriver. Each male clip will
need 2 small screws (l).
Right
Slide the top(T) , Middle panel(M) and bottom panel(B) into the grooves of the
right and left side panels, and then into the groove in the frame below until it
Slide the Back panel into the grooves in the side panels and attach the male
clips to the back panel. Four clips on the left side and four clips on the right
Page 4
Step 7
Step 8
Step 9
insure a level fit.
-4-
Use the long screws(K), and the pre-drilled holes , to attach the back panel to
the edges of the bottom panel.
Secure the toe kick into the bottom of the cabinet (using two small screws(I)
in each of the two clips).
Put the shelf pins on the left and right side panels using the holes provided. Be
sure the pegs on the right & left are in the same position on each side to
The larger screws are optional. They can be installed at the top and middle of the inside of
the cabinet prior to mount to the wall. The Larger screws(M 2 3/8'') are needed.
Loading...