Caution: You should read this before proceeding
Chair
Label Picture Description QTY
A Backrest/Leg 1
B Seat/Leg 1
Label Picture Description QTY
①
Washer 6
Page 1 OF 5
②
Bolt (M6*16mm) 6
③
Allen Key 1
Before
Beginning
Assembly:
Overview
This Chair has multiple parts and may require up to 30 minutes to assemble. To give
you an overview of the Chair parts, the above picture is provided to help you put the
various parts into perspective. Please read through the instructions below to
familiarise yourself with the parts and steps before assembly.
Backrest/Leg(A)
Seat/Leg(B)
FRONT FACING
Page 2 OF 5
Step 1
Open the carton and place all the parts onto a clean, non-marring surface.
Attach the Seat/Leg(B) to the Backrest/Leg(A) with Washers(①) and Bolts(②) using
the Allen Key(③) as shown above.
Do not fully tighten any Bolts at this time. Lock tightly at the end.
Step 2
Page 3 OF 5
Stand the Chair up.
Place the Chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit on the Chair.
This will help align all parts at all joints.
Then get off the Chair, and in a sequential manner, proceed to tighten all Bolts.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on to the next one. This may
cause the frame to warp. If the chair wobbles after tightening, loosen the Bolts
and execute the same process.
If the Chair is not stable it could lead to damage of the product.
Your Chair is ready for use.
This Chair can only be used on a flat and level surface.
Page 4 OF 5
Page 5 OF 5
Loading...