PENDANT LIGHT (ROD)
Assembly Instructions
CAUTION
• Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect in
the wire, do not attempt installation.
TOOLS REQUIRED
• Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning o the circuit breaker or by
removing the fuse at the fuse box.
Ladder
Safety
glasses
Electrical
tape
Phillips
screwdriver
screwdriver
PliersFlat blade
Wire
strippers
Canopy
Fixture Shade Socket Ring Long Rods
Mounting Unit Mounting Screws Wire Nuts Cap Nuts
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
page 1
PENDANT LIGHT (ROD)
Assembly Instructions
STEP 1
Screw the rods to the fixture. Make sure to feed
the branchwires of the fixture through the rods
during assembly. Remove or add rods to adjust
the height. Secure the shade to the fixture using
the socket ring.
STEP 2
Use the mounting screws to attach the mounting unit to the
junction box
STEP 3
Make the electrical connection from the junction box to the
fixture. Connect the ground wire to the mounting unit using the
preinstalled green ground screw. Then, connect the positive,
negative and ground wires with the supplied wire nuts. Secure
with electrical tape
Connect Clear, Brown, Gold or
Black Parallel Wire without tracer
(round & smooth) or Black Fixture
Wire to:
Black or Red Supply Wire or
Insulated Wire (other than green)
with copper conductor.
Connect Clear, Brown, Gold or
Black *Parallel Wire with tracer
(square & ridged) or White Fixture
Wire to:
White Supply Wire or Insulated
Wire (other than green) with silver
conductor
Copper
Smooth
Silver
Ridged
page 2
PENDANT LIGHT (ROD)
Assembly Instructions
STEP 4
Place the canopy over the mounting unit and
secure the fixture with the cap nuts.
STEP 5
Install bulb (not included)
page 3
Loading...