Page 1
Label Picture Description QTY
A Chair Seat and Back 1
B Chair Leg Frame 1
Label Picture Description QTY
①
Bolt
(M6x35mm)
5
Caution : Please read this cafrefully before you proceed
Please look in Red Bag for hardware packs and legs.
Chair
Page 1 OF 5
Page 2
②
Washer
5
③
Allen Key
1
Overview
This Chair has multiple parts and may require up to 20 minutes to assemble. To give
you an overview of the Chair parts, the above picture is provided to help you put the
various parts into perspective. Please read through the instructions below to
familiarise yourself with the parts and steps before assembly.
Before
Beginning
Assembly
Front Facing
Chair Seat
and Back(A)
Chair Leg Frame(B)
Page 2 OF 5
Page 3
Step 1
Step 2
Step 3
Unpack and place all parts on a clean, non-marring surface.
Place the Chair Seat and Back(A) on a clean, non-marring surface.
Align the Chair Leg Frame(B) to Chair Seat and Back(A).
A
B
A
B
Page 3 OF 5
Page 4
Step 4
Turn the chair right side up.
Place the chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected.
Gently and carefully, sit into the chair.
This will help align all the parts at all the joint areas.
Then get off the chair, and in a sequential manner, proceed to tighten all screws.
To tighten the Screws at the base of the Backrest, secure assistance from your adult
partner(s).
You may be required to turn the chair, to gain easy access to the secure points.
Turn the chair in a synchronised manner.
CAUTION 1: When tightening the screws, tighten sequentially.
DO NOT tighten any screw fully and then move on to the next one, as this could
cause the frame to warp.
If the chair wobbles after tightening all screws, loosen the screws and repeat
the same process.
WARNING!! IF THE CHAIR IS NOT STABLE , IT COULD CAUSE THE PRODUCT
TO BECOME DAMAGED.
Ensure all screws are fully locked into position.
The chair is ready to be used.
Caution 2: This chair should only be used on a flat, level surface.
Attach Chair Leg (B) to Chair Seat and Back(A) with Bolts(①) and Washers (②) using
the Allen Key (③).
Do not fully tighten the Bolts.
Page 4 OF 5
Page 5
Page 5 OF 5
Loading...