Page 1
Label Picture Description QTY
A Chair Seat And Back 1
B Chair Foot Frame 1
C Fabric Cushion 1
Caution : You must read this before you proceed
CHAIR
Please look in Red Bag for hardware packs and legs.
Page 1 OF 6
Page 2
Label Picture Description QTY
①
Bolt
(M7x90mm)
5
②
Hex Nut
5
③
Pad
5
④
Allen Key
1
⑤
Hex Wrench
1
Before
Beginning
Assembly
Page 2 OF 6
Page 3
Step 1
Overview
This Steel wire chair has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Steel chair parts, the above picture is to help you put
the various parts into perspective. Please read through the instructions herebelow to
familiarise the parts and steps before assembly.
Unpack and place all parts on a clean, non-marring surface.
Page 3 OF 6
Page 4
Step 2
Step 3
Place the Chair Foot Frame (B) onto a clean, soft surface to avoid any scratches or
damages to the product, and then put the Chair Seat And Back (A) upper on the Chair
Foot Frame (B).
Page 4 OF 6
Page 5
Step 4
Fix the Chair Foot Frame (B) with Chair Seat And Back (A) by using Bolt (①), Pad(③),
Hex Nut (②) use Allen Key(④) and Hex Wrench( ⑤).
Repeat the previous step and according to four red circles Mounting Position, Repeat
the same process by affixing Bolts (①), (②), (③)to designated points, Each of the four
red circles above can be assembled first.
DO NOT FULLY TIGHTHEN BOLTS.
Turn the chair right side up.
Place the chair on a LEVEL SURFACE.
Inspect it and make sure all parts are adequately connected then put a fabric cushion
on the chair seat.
Gently and gracefully, sit into to the chair.
This would help to align all the parts at all the joint areas.
Then get off the chair, and in a sequential manner, proceed to tighten all screws.
To tighten the Screws at the base of the Backrest, do secure assistance from your
adult partner(s).
You may be required to turn the chair, to gain easy access to the secure points.
Turn the chair in a synchronised manner.
CAUTION 1: When tightening these screws, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the screws and execute this same process.
WARNING!! IF CHAIR IS NOT STABLE , IT COULD LEAD TO DAMAGING THE
PRODUCT.
Ensure all screws are fully locked into position.
The e chair is ready to be used.
Caution 2: This chair can only be used on a flat, level surface.
Page 5 OF 6
Page 6
Page 6 OF 6
Loading...