Installation Guide
ToolsRequired:
LightSource:
EstimatedAssembly Time:
Preparation:
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
Flatheadscrewdriver,Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
IntegratedLED38W
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Package Contents
Inner Backplate
A
x1
Mounting Screw
B
x4
STEP 1 Install Inner Backplate and Fixture Body-
A. Pass the supply wires and ground wire through the Inner Backplate
(A). Attach the Inner Backplate (A) to outlet box with the head of
green ground screw facing you. Secure it with outlet box screws
(not included). Tighten until snug
B. Refer to Step 2 for wiring connections.
C. Attach the Fixture Body (C) over the Inner Backplate (A) and secure
with Mounting Screws (B). Tighten until snug with screwdrivers.
.
STEP 3 Install Shade to Fixture Body-
A. Insert Shade (D) into the Shade Holder properly.
B. Place Bracket (F) over the side of the Shade Holder, line up the hole
Fixture Body
C
x1
Shade
D
x1
on the Bracket (F) and the mounting hole on the Shade Holder,
secure by threading Lock Screw (E) into the mounting hole, tighten
until sung.
Your fixture is now assembled and ready to use. Enjoy!
Lock Screw
E
x4
F
Bracket
x2
Figure 1
B
C
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from outlet box
Black wire from
outlet box (or Red)
Bare, or Green
Ground wire
from outlet box
Supply Wires and
Ground Wire
Outlet Box
Outlet Box Screw
(not included)
A
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
E
F
FINISH: EARTH BLACK
4.5”
Shade Holder
26”
6.5”
Figure 3
D
4.5”
Green Ground Screw
on the Crossbar
Figure 2
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
1of1
Loading...