Page 1
WALL LEDGE
Maximum load claim
9 in CUBE: HOLDS UP TO 20 lbs (9 kg)
7 in CUBE: HOLDS UP TO 15 lbs (6.8kg)
5 in CUBE: HOLDS UP TO 10 lbs (4.5 kg)
TOOLS NEEDED (Not included in product)
Pencil
Level
Drill
STEP 1
Stud Finder
Screwdriver
HARDWARE (Included in product)
plastic dry wall anchor
Size : 9mm
mounting bracket
Ø x 32mm L
philip head screws
Anchor screw (6mm Ø x 25mm L)
Stud screw (6mm Ø x 30mm L)
STEP 2
NOTE FOR STUD MOUNTING：
◆
Anchor is not necessary for stud mounting.
◆
Additional tool/hardware may be required
for stud mounting, or if on wall surfaces
other than dry wall. Consult your local
hardware store.
1a
Drywall mounting: Choose a desired location.
Mark mounting holes for anchors.
STEP 3
Tighten screws into anchor(s) and the stud(s).
1/8"
(3mm)
1b
Stud mounting: Choose a desired
location. Use a stud finer and mark
the location of studs.
STEP 4
Hang cube.
2a
Drywall mounting: Tighten the anchors into
dry wall with Philips screw driver until anchors
are flush with the wall surface.
If cube cannot hang on to the screws, untighten the screws slightly and re-hang.
Repeat as necessary.
2b
Stud mounting: Drill pilot hole and drive
the stud screw into the pilot hole.
Loading...