Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
WARNING:
NOTE: 1.Before installing, consult local electrical codes for wiring requirements.
2.Please read the instructions carefully before you install this fixture. If you
are not familiar with installations, please consult the qualified electrician.
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Installation Steps
1.Thread the cord through the canopy and strain relief. Measure
the desired length of the cord (A) from the canopy to the glass
and leave additional 9" cord (B) above the canopy(include the
canopy)(See Fig.1).Then you can (1) cut off the unnecessary
cord or (2) just leave the unnecessary cord in the canopy.
Once you want to decrease or indecrease the length of the
cord exposing outside,you still have a six feet cord to adjust.
2.Adjust strain relief at 9" position from the top of the cord.
3.Mark the 3" cord (C) from the top of the cord (B). Use a
knife to peel off the insulation of the cord (C) carefully
to show the 3 inside wires out. (See Fig. 1)
Caution : Cutting too deep may cut off three inside wires
and destroy the insulation surface of the three inside wires.
4.Peel off the 3 wires from the top about 3/8" long(D) to expose
the copper for wiring.
5.Unscrew the screws from the canopy.
6.Mount mounting strap securely to ceiling box with 2 mounting
screws through slot in mounting strap.
7. Make wire connections with wire nuts:
---Connect White Wire from the fixture to White Wire from
power source with a wire nut.
---Connect Black Wire from the fixture to Black Wire from
power source with a wire nut.
---Connect Green Grounding Wire from the fixture to Green
Grounding Wire from power source with a wire nut.
Carefully tuck the wires back into the ceiling box .
8. Pull the cord ( A ) down slightly until the strain relief touches the
hex nut. Attach the canopy to the mounting strap by using 2 screws.
Note: Adjust the strain relief can decrease or increase the
length of cord exposing outside.
9.Unscrew two set screws from the support and leave the third
one on it. Insert the third screw into one of the holes of grass
shade.Thread the other 2 screws into the other holes of glass
shade and secure them on the support.(See Fig.2)
10.Hold up the glass shade to make the socket out of the glass
shade, and install a bulb.(please do not exceed the maximum
capacity, which is recommended on the package.)
11.Turn on the power at fuse or circuit box.
Cord (A)
Mounting Strap
Mounting Screw
Wire Nut
Screw
Strain Relief
Canopy
Hex Nut
D(3/8")
C(3")
B(9")
A
FIG.1
Set Screw
Support
Socket
Glass Shade
Bulb
FIG.2
Loading...