Installation Instructions
Product Information
Flush Mounted Euroline Series Features:
- White Baked Enamel Steel Body
- European Hinges
- Touch Latch Magnet
- Adjustable Glass Shelves
**Professional Installation is recommended to insure proper installation.
**Door removal is recommended, but not required for installation.
**Please do not stand your medicine cabinet on end while unboxing. Lie the cabinet down mirror side up prior to
installation. Set on a clean surface, like a towel or carpet to avoid damage.
**Prior to discarding the packaging, locate shelves, door hardware, and screws where applicable.
Installation Steps
1. Make sure the wall opening is plumb and level prior to installation. This will allow the door to operate
properly. (Figure 1)
2. Allow for 1” of clearance on height elevation above any obstructions as illustrated in Figure 2. Note the
door will exceed the wall opening by 1” on top and bottom of most cabinets. Refer to technical data for
exact sizes.
3. Single door cabinets can be inverted in for right or left hand installation. Locate the hinge to properly
select door swing desired. Insert cabinet into wall opening making sure the flange covers the rough wall
opening evenly. You may need to insert shims as needed (not included). (Figure 3)
4. For drywall/wood stud applications insert wood screws into pre-drilled mounting holes located on the
interior sides of the cabinet. (Pro-tip do not overtighten with this will wrack the cabinet) use a level to test
that the cabinet is plumb. (Figure 4)
5. Insert shelf clips at desired height locations and place plastic shelf. Do not install shelves prior to cabinet
installation.
NOTICE:
1. Do not install cabinet with damaged or broken glass. Contact the point of sale for further instructions on
replacements.
2. The installation instructions provided are for typical drywall/wood stud type walls. Additional hardware
may/will be required for different wall types. Always make sure you adequately brace the cabinet for secure
installation. Do not screw directly into drywall without proper bracing.
1/2
Width
Level
Height
Plumb
1” Clearance
Fig. 2Fig. 1
Fig. 3 Fig. 4
2/2
Loading...