Caution: You must read this before you process
TABLE
CAUTION : This Table is NOT a TOY.
Keep your child / children at bay during the assembly process.
For moving the Table and to prevent damage to the Table, two adults are
needed to execute this action.
Page 1 OF 7
Picture
Description
QTYLabel
A
B
C
D
Table Top
First Leg Frame (with
Leveler)
Second Leg Frame (with
Leveler)
Lower Cross Block
1
1
1
1
E
Label Picture
Label
①
②
③
④
⑤
Upper Cross Block
Description
Short Bolts (M8x55mm)
Sleeve Nut (M8x20mm)
Long Bolts (M6x90mm)
Screw (M7x45mm)
Allen key
1
QTY
5
5
2
9
2
6
Iron washer
Page 2 OF 7
5
Before Beginning Assembly:
Table Top (A)
Upper Cross Block (E)
First Leg
Frame (B)
Lower Cross Block (D)
Second Leg
Frame (C)
FRONT FACING
This Table has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Table parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Page 3 OF 7
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
c
B
c
B
B
With the assistance of your partner, position the First Leg Frame(B) to the
Second Leg Frame © as picture above.
Secure First Leg Frame(B) with the Second Leg Frame (C) by using
Long Bolt ( ) and Allen Key ( ).③ ⑤
. Note: This step, legs with leveler will be upside down
Do not fully tighten the Bolts.
Page 4 OF 7
Step 3
D
With the assistance of your partner, position the Lower Cross Block (D) onto
the Leg Frames in Step 2. Secure by using Screws ( ) and the Allen Key ( ).④ ⑤
Do not fully tighten the Screws.
Step 4
E
With the assistance of your partner, turn Leg Frame in step 3 180 degree.
Position the Upper Cross Block (E) onto the Leg Frame as picture above.
Secure by using Screws ( ) and the Allen Key ( ).④ ⑤
Do not fully tighten the Screws.
Page 5 OF 7
Step 5
STEP 5.1 STEP 5.2
Place Table top (A) with its underside skywards onto a clean, soft surface
to avoid any scratch or damage to the product.
Position Leg Frame in step 4 onto Table Top (A)
Using two Short Bolts ( ), two Sleeve Nuts ( ), two Iron Washer ( ) and 5.1)
Allen Key ( ) to connect middle support bar of Table Top (A) and Leg Frame (B & C).
⑤
Using two Short Bolts( ), two Sleeve Nuts ( ), two Iron Washer ( ) and 5.2)
Allen Key ( ) to connect side support bar of Table Top (A) and Leg Frame (B & C).
⑤
① ②
① ②
⑥
⑥
Do not fully tighten the Bolts.
Step 6
LEVELER
With assistance from your adult partners, turn the Table back to normal flat
ground
EXERT pressure, floorwards, onto the Table.
This pressure will help the Legs and Table Top reach alignment at all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Screws and Bolts until evenly
secured.
Inspect the Table and make sure all parts are adequately connected.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Page 6 OF 7
Page 7 OF 7
Loading...