Page 1
Assembly Instructions
needed to execute these actions.
Caution: You must read this before you proceed
Please look in the First Leg Panel for hardware packs.
Table
Caution: This Table is NOT a TOY
Keep your child/ children at bay during the assembly process.
For moving the Table and to prevent damage to the Table, two adults may be
Page 1 of 6
Page 2
Labe
Pan
el
①
②
Par
ts List
l Picture Description QTY
A Table Top 1
F
B
irst Leg Panel
(Labelled B)
Second Leg
1
C
Hardware
Labe
l Picture Description QTY
Assembly Preparation
Before Beginning Assembly:
(La
belled C)
Screws
(M6x45mm)
Allen Key 1
1
9
Page 2 of 6
Page 3
Assembly
Overview
Steps
Ta
ble Top (A)
Second
Panel (C)
Leg Panel
First
(B)
FRO
This Table has multiple parts and may require up to 30 minutes to assemble. To give you
an overview of the Table parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the
parts and steps before assembly.
NT FACING
Leg
Step 1
npack and place all parts on a clean non -marring surface.
U
Page 3 of 6
Page 4
tep 2
Position sepera
ted point of the Second Leg Panel (C) over the First Leg Panel (B) on
to
the Table Top(A).
②)
Place t
he Table Top ( A) facedown on a clean, non-maring suface.
Position the First
Leg Panel (B) on to the Table Top(A).
②
B
A
A
C
B
S
2
1
Insert
using the Allen Key(
On
three Screw (①),through the mounting positions of the First Leg Panel ( B) and affix
)
ly loosely tighten the Screws.
Step 3
Step 3.1
2
Step 3.3
1
2
1
Step 3.2
1)
3.
3.2) Insert
into the Table Top(A) and affix using the Allen Key(②)
3.3) Affix First Leg Panel (B) and Second Leg Panel (C) using Screw (①) with Allen
Key(
ly loosely tighten the Screws.
On
four Screws (①)through the mounting positions of the Second Leg Panel (C)
Page 4 of 6
Page 5
Inspect Table and make sure all parts are adequately connected.
Step 4
If wobble
Test again
30cm-50cm
Place the Table right side up on a LEVEL SURFACE to see if it wobbles.
If it wobbles,lift the Table to some 30cm to 50cm height from the ground.
Keep your feet and tose weell away from the drop zone.
Drop the Table freely and vertically with the four legs,hi
time.This Drop Test will help to ensure that all the Screws and gaps all reach full alignment
status.
Test again for evenness on a LEVEL SURFACE .
If no wobbles are found, proceed to tighten all Screw.
CAUTION: When tightening the Screw tighten sequentiall.DO NOT tighten any Screw
fully and then move towards the next one. This could cause the frame to warp.
If there are still wobbles ,loosen the Screws and execute this same drop test.
If the Table is not stable, it could lead to damage to the product.
t
ting the ground,at the same
Step 5
Your Table is ready for use
This Table can only be use on a flat, level surface.
Page 5 of 6
Page 6
Page 6 of 6
Loading...