Page 1
LED DISK LIGHT
Assembly Instructions
CAUTION
• Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect in
the wire, do not attempt installation.
TOOLS REQUIRED
• Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning o the circuit breaker or by
removing the fuse at the fuse box.
Ladder
Safety
glasses
Electrical
tape
Phillips
screwdriver
screwdriver
PliersFlat blade
Wire
strippers
Fixture
Mounting Screws Wire Nuts
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
page 1
Page 2
LED DISK LIGHT
Assembly Instructions
STEP 1
Remove the lens of the fixture.
STEP 2
Make the electrical connection from the junction box to the
fixture. Connect the positive, negative and ground wires
with the supplied wire nuts. Secure with electrical tape
Connect Clear, Brown, Gold or
Black Parallel Wire without tracer
(round & smooth) or Black Fixture
Wire to:
Black or Red Supply Wire or
Insulated Wire (other than green)
with copper conductor.
Connect Clear, Brown, Gold or
Black *Parallel Wire with tracer
(square & ridged) or White Fixture
Wire to:
White Supply Wire or Insulated
Wire (other than green) with silver
conductor
Copper
Smooth
STEP 3
Install the support screws into the junction box (not included)
Line up the holes in the fixture with the support screws and
rotate the fixture until the support screws are aligned with
the smaller section of the mounting hole
Secure the support screws and install the lens.
Silver
Ridged
page 2
Loading...