Page 1
FLUSHMOUNT
Assembly Instructions
CAUTION
• Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect in
the wire, do not attempt installation.
TOOLS REQUIRED
• Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning o the circuit breaker or by
removing the fuse at the fuse box.
Ladder
Safety
glasses
Fixture Shade
Electrical
tape
Phillips
screwdriver
screwdriver
PliersFlat blade
Wire
strippers
Mounting Unit Mounting Screws Wire Nuts Finial
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
page 1
Page 2
FLUSHMOUNT
Assembly Instructions
STEP 1
Use the mounting screws to attach the mounting unit to
the junction box
STEP 2
Make the electrical connection from the junction box to the
fixture. Connect the ground wire to the mounting unit using
the preinstalled green ground screw. Then, connect the
positive, negative and ground wires with the supplied wire
nuts. Secure with electrical tape
Connect Clear, Brown, Gold or
Black Parallel Wire without tracer
(round & smooth) or Black Fixture
Wire to:
Black or Red Supply Wire or
Insulated Wire (other than green)
with copper conductor.
Connect Clear, Brown, Gold or
Black *Parallel Wire with tracer
(square & ridged) or White Fixture
Wire to:
White Supply Wire or Insulated
Wire (other than green) with silver
conductor
Copper
Smooth
STEP 3
Install bulbs (not included). Place the fixture and shade over
the mounting unit and secure the assembly with the finial.
Silver
Ridged
page 2
Loading...