EBAA Iron 2512 Installation Manual

Series 2512

Restraint for C900 PVC Pipe at PVC Fittings

Installation Instructions

1. The Series 2500 is designed for restraining AWWA C900 PVC pipe to

molded or fabricated ttings. It has a split, serrated restraint ring on
the spigot and a split non-serrated ring on the tting.

2. Assemble the tting per the tting manufacturer’s instructions.

3. Install both halves of the split non-serrated bell ring on the tting
behind the gasket hump. Install the side bolts and tighten each to 110
ft.-lbs. (60 ft.-lbs. on 4” and 6”.)

CONTENTS

4. Slide the bell ring toward the gasket hump so that it ts snugly behind
the gasket hump.

5. Remove the side bolts from the serrated restraint ring. Use the tie
bolts to determine the proper location of the restraint ring on spigot.
Allow enough room on tie bolt to fully engage the nuts.

6. Install both halves of the restraint ring at the proper location, tapping
each half into place. Make sure that the complete ID of the ring is
touching the pipe before installing the side bolts. Tighten the side
bolts evenly to 110 ft.-lbs. (60 ft.-lbs. on 4” and 6”.)

7. Place nuts on the tie bolts and tighten until they are snug. Allow
enough room on the tie bolt to fully engage the nut with several
threads showing. Do not tighten these bolts enough to force the spig-

ot further into the bell of the tting.

0218-A

Qty. Description

1 12 inch 1500 Split Restraint

Ring

1 12 inch 2500 Split Back Up

Ring

4 Low Alloy Steel Tie Rods

w/ Nut

Restraints Made in The USA

For use on water or wastewater pipelines subject
to hydrostatic pressure and tested in accordance

with either AWWA C600 or ASTM D2774

APPROXIMATE SHIPPING WEIGHT: 43.80 lbs.

Copyright 2018 © EBAA IRON, Inc. All Rights Reserved

Series 2512

Restraint for C900 PVC Pipe at PVC Fittings

2512000000

EBAA IRON SALES, Inc.

P.O. Box 857, Eastland, TX 76448

Tel: [phone]

Fax: [phone]

Toll: [phone]

[e-mail]

www.ebaa.com

Made in the USA