EBAA Iron 1604 Installation Manual
Series 1604
Bell Restraint Harness for C900 PVC Pipe
Serrated Restraint Ring, Non-Serrated Bell Ring
Installation Instructions
1. The Series 1600 is designed for restraining push-on, C900 PVC pipe
bells. It has a split, serrated restraint ring on the spigot and a split
non-serrated ring behind the bell..
2. Assemble the push-on joint per the pipe manufacturer’s instructions.
3. Install both halves of the non-serrated bell ring around the pipe behind
the bell. Install the side bolts and tighten each to 60 ft-lbs (110 ft-lbs
on 8 inch, 10 inch and 12 inch).
CONTENTS
4. Slide the bell ring toward the bell so that it ts snugly behind the bell.
5. Remove the side bolts from the serrated restraint ring. Use the tie
bolts to determine the proper location of the restraint ring on the spigot. Allow enough room on the tie bolt to fully engage the nuts.
6. Install both halves of the restraint ring at the proper location, tapping
each half into place. Make sure that the complete ID of the ring is
touching the pipe before installing the side bolts. Tighten the side bolts
evenly to 60 ft-lbs torque (110 ft-lbs on 8 inch, 10 inch and 12 inch).
7. Place nuts on the tie bolts and tighten until they are snug. Allow
enough room on the tie bolt to fully engage the nut with several
threads showing. Do not tighten these bolts enough to force the spigot
further into the bell of the joint.
0912-O
Qty. Description
1 4 in. 1500 Split Restraint
Ring
1 4 in. 1604 Split Restraint
Ring
2 Low Alloy Steel Tie Rods w/
Nuts
Restraints Made in The USA
For use on water or wastewater pipelines subject
to hydrostatic pressure and tested in accordance
with either AWWA C600 or ASTM D2774
APPROXIMATE SHIPPING WEIGHT: 14 lbs.
Copyright 2018 © EBAA IRON, Inc. All Rights Reserved
Series 1604
Bell Restraint Harness for C900 PVC Pipe
Serrated Restraint Ring, Non-Serrated Bell Ring
16040000
EBAA IRON SALES, Inc.
P.O. Box 857, Eastland, TX 76448
Tel: (254) 629-1731
Fax: (254) 629-8931
Toll: (800) 433-1716
contact@ebaa.com
www.ebaa.com
Made in the USA
Loading...