EAZYLIFT TECHNOLOGY EC5020BA User Manual

User manual

Function specification

1. Auto standby: if there is no input signal in 5s, the system will enter into standby

status.

2. Low voltage alarm: if the voltage is less than 4.5V, when the user press lock key

or unlock key, it will sound blares first, then open or close the lock.

3. Power supply: DC/6V 4 x AA battery

4. Support the transmitter to open the lock

5. Support setting password to open the lock

6. Support the key to open the lock

7. Buzzer remind

Sound Status meaning
One short beep Key sound
One long beep Enter changing password status, change password

succeed, transmit coding, password recovery

Five short beeps Wrong password, Change password mistake
One bass blare Low voltage alarm

Transmitter unlock/lock specification

1. Set the power switch to “NO”, then press the learning button “FOB learn”, the
buzzer sounds slow ticks, if press till 5s, the buzzer sounds one long tick and go
back to standby status, all the stored transmitters are deleted.

2. If release the button in 5s, the buzzer does not sound, it enters into transmitter

learning status, press the open key on the transmitter, the buzzer sounds a long tick
and go back to standby status, it means learning succeed. If you want to learn
another transmitter, do that again. If do not learning any transmitter or learning
failure in 10s, the buzzer sounds quickly ticks and goes back to standby status.

3. It can at most store 20pcs transmitters.

4. After learnt, press the lock key on the transmitter, the door will lock; press the

unlock key on the transmitter, the door will unlock.

Setting password lock/unlock specification

1. Normal use

Unock: enter password and press unlock key, if right password, it will one long

beep and unlock; if wrong password, it will five short beeps.

Lock: enter password and press lock key, if right password, it will one long beep

and lock; if wrong password, it will five short beeps.

Specification

(1).If do not press unlock key or lock key in 5s after entered the password, it

needs to enter the password again.

(2). If the password is 027, then 27, 0027 and this kind of password are

wrong.

(3).If the password is more than 8 units, the password is wrong.

2. Change password
The default password is 1234. Press and hold on the key “8”, then press lock

key, the buzzer sounds a long beep, it enters into change password status, enter
the current password, then press lock key, enter a new password, such as
28111376 (less than 8 units), press lock key again and enter the new code
28111376 again, finally press lock key, the buzzer sounds a long beep, it means
change password succeed.

If the new password is more than 8 units, or the two entered new passwords are

not the same, the buzzer will sound five short beeps, it means change
password mistake. In the change password status, when it needs to enter a
new password, it the user does not enter any password, but press the lock
key two times, the password is 0, it means no password, so press the lock
key or unlock key can control the lock.

3. Delete password

Press and hold on “code reset” till to sound long tick, the password will receover

to initial password “1234”

Key using specification

Use the key to open the lock.