Eaton HHB1BATR Manual Inside Page

PMS 314

Home Status

Everything is OK

MATCH CMYK

Open/Closed Sensor

Set up Test Place and use

FOLD

PMS 431

MATCH CMYK

DOES NOT PRINT

11”

3.6875” 3.6875”

3.625”

5.625”

REMOVE the sensor

cover and insert the
battery. The green LED
light inside the sensor
should flash four times
if the battery is good.
Replace the cover.

CLICK the Home Key thumbwheel
to wake the screen, then SLIDE
the Home Key into the Slide
Channel on the top of the sensor.

Follow the instructions on the
Home Key screen to join the
sensor to the system, name it, and
set In-Home A
and "CallMe" A

wareness

wareness.

ROLL OVER and highlight
the Open/Closed icon on the
Home Key.

Test the sensor by moving its
two parts together and apart
while checking the Home Key
screen for feedback. (The
sensor is “closed” when the
two sensor parts are within
1/2 inch of each other.)

Front Door

Closed for 45mins

Front Door

Opened for 5mins

Front Door

Closed for 45mins

A

B

Take the sensor and the
Home Key to the location
where you want to place
it. Using the Home Key,

DOUBLE-CLICK

Home Status icon and

CLICK Check Ran

to go to the built-in Range Finder.

at the

ge?

Done, go back?

Check Range?

>

If you are out of range, move
closer to the Base Station or

In range

add a Range Extender.

If the sensor is in range of

A

part to the edge of a door,
window, or cabinet, and the

the Base Station, attach one

B

other within 1/2 inch of it.
Mount each part by attaching
the enclosed adhesive tape to the
back or by using two #4 wood
screws (not included).

BLEED = .125”

Need help? Call 1-800-813-2199 for customer support or visit www.homeheartbeat.com

If Your Open/Closed Sensor . . .

• will not respond, make sure the battery in the sensor is installed correctly.

• does not send a signal to the Base Station, move the sensor and Base Station closer together (or consider getting a Range Extender).

DOES NOT PRINT

FOLD

BLEED = .125”