Eaton 600 A 15 kV class push-OP, 600A 25 kV class push-OP, 600 A 35 kV class push-OP Installation Instructions Manual

COOPER POWER
SERIES
Deadbreak Apparatus Connectors
MN650055EN
Effective May 2017 Supersedes May 2009 (S600-65-1)
600 A 15/25 and 35 kV class push-OP insulated standoff bushing installation instructions
EYEBOLT
LATCH HANDLE
DEADBREAK
LOCKING TEETH
BAIL BRACKET
LOCKING SLOT
PUSH
HERE
PUSH PLATE
OPTIONAL HITCH PIN
DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY
The information, recommendations, descriptions and safety notations in this document are based on Eaton Corporation’s (“Eaton”) experience and judgment and may not cover all contingencies. If further information is required, an Eaton sales office should be consulted. Sale of the product shown in this literature is subject to the terms and conditions outlined in appropriate Eaton selling policies or other contractual agreement between Eaton and the purchaser.
THERE ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, OTHER THAN THOSE SPECIFICALLY SET OUT IN ANY EXISTING CONTRACT BETWEEN THE PARTIES. ANY SUCH CONTRACT STATES THE ENTIRE OBLIGATION OF EATON. THE CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES.
In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or other-wise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited to damage or loss of use of equipment, plant or power system, cost of capital, loss of power, additional expenses in the use of existing power facilities, or claims against the purchaser or user by its customers resulting from the use of the information, recommendations and descriptions contained herein. The information contained in this manual is subject to change withoutnotice.
iINSTALLATION INSTRUCTIONS MN650055EN May 2017
Contents
DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY ....................................I
SAFETY FOR LIFE .........................................................................III
SAFETY INFORMATION ....................................................................III
Safety instructions .............................................................................. iii
PRODUCT INFORMATION ................................................................... 1
Introduction ....................................................................................1
Read this manual first ............................................................................1
Additional information ............................................................................1
Acceptance and initial inspection ...................................................................1
Handling and storage .............................................................................1
Standards .....................................................................................1
INSTALLATION PROCEDURE ................................................................ 2
Equipment required ..............................................................................2
Assembly and operation ..........................................................................2
ii INSTALLATION INSTRUCTIONS MN650055EN May 2017
Loading...
+ 5 hidden pages