EasyPix GoXtreme Wi-Fi User Manual

1

User Manual

2

Thank you for buying the GoXtreme WiFi action camera. Before

start using this product, please read this manual carefully to

maximize its performance and extend the life of the product.

Appearance and Buttons

1. Shutter button 7. LED light

2. LCD display 8. Micro HDMI port

3. Power / Mode button 9. Micro USB port

4. Lens 10. Micro SD card slot

5. Wi-Fi switch and status indicator (red) 11. Reset button

6. Microphone

3

LCD Display Illustration

Turn on the GoXtreme WiFi, the LCD will display the following

status and settings:

1. Camera mode

2. Video recording mode (default)

3. Wi-Fi icon (display when enabled)

4. TF card icon (display when loaded)

5. Resolution icon:

In camera mode, HI stands for 8 Mega Pixels (3264x2448),

and in video recording mode, it stands for FHD

(1920x1080,30fps);

In camera mode, LO stands for 5 Mega Pixels (2592x1944),

and in video recording mode, it stands for 720P

(1280x720,30fps);

HILO only displays in video recording mode, standing for 720P

(1280x720,60fps).

6. Mute mode, displays when enabled, and disabled by

default.

7. Counter, displays up to 999.

4

8. Timer, displays hours and minutes.

9. Battery icon: current battery level of the camera.

Note: the above icons may vary according to the status of the

GoXtreme WiFi.

Working Mode Flow Chart

After turn on the GoXtreme WiFi, you can press the

Power/Mode button to switch the following modes in turn:

In video mode, press the Shutter button to start recording, LED

flash, and press it again to stop;

In camera mode, press the Shutter button to take photo.

Use your GoXtreme WiFi

When you use the GoXtreme WiFi for the first time, please:

1. Insert a micro SD or micro SDHC card, as shown in the

following picture.

Camera mode (8MP)

Camera mode (5MP)

Video mode (720P ,60fps)

Video mode (720P,30fps)

Video preview mode (1080P default)

5

High speed card at least Class 4 is recommended; Turn off the DV

before inserting or removing the card.

2. Charging the battery. The DV uses built-in rechargeable

lithium battery. When the DV is off, connect it to the PC via

USB cable to charge the battery. During charging, the status

indicator (blue) will light on, and the indicator off when

charging completes.

Note: When the DV is on, connecting it to the PC will not

charge.

Turn on/off

1. Turn on: press and hold the button for about 3 seconds,

LCD displays “ON” and a beep can be heard from buzzer.