Easy-kleen Magnum 4000 Ultra, Magnum 4000 Plus, Magnum 4000 Gold, Magnum 4000 3600 User Manual

MAGNUM 4000 SERIES

OWNER’S MANUAL

ULTRA

GOLD

NEW

2014

PLUS 3600

Call 1-800-315-5533

Email [e-mail]

Easy Kleen Pressure Systems

1-800-315-5533

This manual contains operational information that is specific for

Hot and Cold Water Pressure Washers.

Read the following instructions carefully before attempting to assemble,

install, operate or service this pressure washer. Failure to comply with the

instructions could result in personal injury and/or property damage.

CONTENTS

Safety Information

Introduction

Operating Instructions

Chemical Application

Winterization of Pressure Pump and Coil

General Maintenance Instructions

Maintenance Checklist

Glossary of Terms

Warranty

Pressure Washer Components Diagram

Troubleshooting Guide

** Hot Water Pressure Washers Only

SAFETY

WARNING

: To reduce the risk of

carefully before using.

WARNING

: Use protective

WARNING

: This machine

ear protection must be worn.

The safe operation of our pressure washing systems is the FIRST priority of Easy Kleen. This
will only be achieved by following the operation and maintenance instructions as explained in
this manual and all other enclosed manuals.

IMPORTANT SAFETY INFORMATION:

ALL

CAUTIONS

INJURY OR DAMAGE TO EQUIPMENT.

AND SAFETY WARNINGS MUST BE

FIR

S

FOLLOWED

T

TO AVOID

THIS EQUIPMENT IS TO BE USED ONLY BY TRAINED OPERATORS
ALWAYS BE ATTENDED DURING OPERATION.

injury, read operating instructions

Read the instructions in this manual carefully before attempting to assemble,
install, operate or service this pressure washer. Failure to comply with the
instructions could result in personal injury and/or property damage.

AND MUST

** Hot Water Pressure Washers Only

eyewear and clothing when
operating equipment in order
to avoid personal injuries.

exceeds 85db. Appropriate

IMPORTANT SAFETY INFORMATION

WARNING

:

Risk of explosion.

or torch is permitted.

WARNING

:

Flammable liquids can

WARNING

:

Risk of fire. Do not

WARNING

:

Keep water spray

WARNING

:

Risk of asphyxiation.

ventilated area.

WARNING

:

Risk of injection or

clear of nozzle spray.

Operate only where open flame

Use only #2 furnace oil or Diesel fuel in the burner fuel tank.

add fuel when operating machine.

Never use gasoline, crankcase draining, or waste oil in your burner fuel tank.
Never run pump dry or let the pump run with the trigger gun released for
more than 2 minutes. The minimum clearance to any combustible material is
12 inches.

away from electrical wiring.

All electrically powered equipment must be grounded at all times to prevent
fatal electric shots. Do not spray water on or near electrical components. Do not
touch electrical components while standing in water or when hands are wet.
Always make sure machine is disconnected from power source before servicing.

create fumes which can ignite, causing
property damage or severe injury.

** Hot Water Pressure Washers Only

Use this product only in a well

Use equipment in a well ventilated area to avoid carbon monoxide poisoning or
death. This machine must never be connected to a Type B gas vent.

severe injury to persons. Keep

High pressure spray can cause serious injuries. Never point pressurized spray
at any person or animal. Handle the spray assembly with care.

IMPORTANT SAFETY INFORMATION

WARNING

:

Risk of injury. Hot

WARNING

:

Hot discharge

WARNING

:

Trigger gun kicks

WARNING

:

Risk of injury

WARNING

:

Protect from freezing.

surfaces can cause burns.

back. Hold with both hands.

Hold firmly to the gun and wand during start up and operation of the machine.
Do not attempt to make adjustments while the trigger gun is in operation.

from falls when using ladder.

fluid. Do not touch or direct
discharge stream at persons.

Do not overreach or stand on anything unstable. Keep a good balance and
make sure to keep a steady footing at all times.

It is important to keep your machine from freezing in order to keep it in its best
working condition. Failure to protect your machine from freezing may cause
damages to the machine and personal injuries may occur as a result.

If you need further explanation of any of the information in this manual,
suspend any activity involving the equipment and call our toll free number

for assistance, 1-800-315-5533.

** Hot Water Pressure Washers Only

OPERATING INSTRUCTIONS

1. P

erform pre-start

the machine. This is essential for the safe, effecti
optimum performance from your system ONLY if these instructions and inspections are
followed. Any indication that the pressure washing system was not operated and maintained
according to these instructions may cancel the manufacturers’ warrant

maintenance inspection on all applicable systems prior to operating

ve and efficient operation. You will get

y.

Location – Gasoline

Controls – Make sure all

Pu mp – O il l ev el - Level the pressure washer. Be sure oil level in the pump is

correct on dip stick. If the level is low, add the correct oil to the

SAE 30 W NON-DETERGENT OIL OR HYDRAULIC 68. DO NOT OVER FILL.

Gas Engine - Gasoline level – The engine is a 4 cycle and uses

fuel. DO NOT USE MIXED FUEL. Refer to the engine operation manual included with
your

pressure-washing unit.

Gas Engine - Oil level – The engine is a 4 cycle and uses 10W30 detergent oil. Refer to
Glossar

**Oil Fired Burner - Oil Tank Level – #2 Furnace oil is
Hot Water Pressure
Diesel fuel may be used as an alternative. Do not overf

y or engine manual.

powered

controls

Washers.

machines must be outdoors in a well ventilated area.

turned to the off position.

proper level. USE ONLY

It burns cleaner

regular

recommended fuel for

and

the burner requires less

ill burner tank

octane, unleaded

Oil Fired

maintenance.

.

Visually inspect all e

Visually inspect all hoses, nozzles and guns to assure they are in

replacements

2. Attach the

Ensure that the quick disconnect connections are tightly locked t
pull on the hose to confirm.
Attach the wand nozzle specific to the task requirements (i.e. chemical or pressure wash).

[Quick Coupling Operation – Pull back sleeve end and insert male end into fitting, release
sleeve and confirm connection.]

** Hot Water Pressure Washers Only

high-pressure

lectrical components to assure they are in

no signs of exposur

are necessar

y they must be rated to withstand the machines operating

pressure and temperatur

hose to the outlet coupling on the coil heat exchange system.

e,

breakage or splicing.

es.

good condition, showing

good condition. If

ogether

. Apply a sharp