EASYBOOT GLOVE APPLICATION
The Easyboot Glove is a lightweight, slim prole,
form-tting boot that is easy to apply.
It was designed to t like a second skin over the hoof without adding bulk
or width. This seamless boot hugs the hoof and responds like a natural foot.
Flexible and tough, the Easyboot Glove adds traction and protection to the
hoof while allowing a free stride and natural breakover. Like a glove, this
boot provides protection without hindering mobility.
The Easyboot Glove material stretches over the hoof and clings to the wall so
that debris stays out of the boot even through sandy and muddy conditions.
No external hardware means that there is no need to worry about grass or
sticks getting caught in the boots. The molded urethane cap at the rear of the
gaiter ts the contours of the heel bulb while offering generous proportions
of stretch and strength.
Sold Individually.
1. 2.
Fitting the Easyboot Glove to Your Horse
1.
Pick up the horse’s leg and support the cannon bone between your knees
so that you can use two hands when applying the boot.
2. Fold the gaiter back to get it out of the way.
3. Using technique rather than strength, place the boot over the horse’s
toe and, using a slight back and forth twisting motion, slide the boot
on the rest of the way. Put the foot down on the ground and allow
the horse to put weight into it. Don’t use the gaiter to pull the boot
on. If you are having trouble, please refer to the tting video found at
easycareinc.com.
Check for proper t. Make sure all portions of the boot (with the exception
4.
of the gaiter) are below the hairline. The boot should be very snug and
not twist on the hoof. Do not use the boot if it is loose or if the main
part of the boot touches the coronary band.
5. Fasten the Easyboot Glove Gaiter.
» Pull the side of the gaiter with the loop (fuzzy side of the hook
and loop) tightly around the pastern. Notice the end is long and
will not be in the center.
» Pull the side of the gaiter with the hook (rough side of the hook
and loop) tightly. This will overlap the rst part of the gaiter
that is now against the pastern.
» Fasten the loop strap.
» Pull the hook side over the loop strap.
6.
The tighter the t, the better the boot will perform. Overlap the hook and
loop straps as much as needed to insure a tight t and avoid rubbing
issues. (See illustration below)
Removing the Easyboot Glove
1. Unfasten the gaiter straps.
2. Slip the boot off the hoof.
3.
5.
4.
Optional Power
Strap creates snug
t (not included)
6.
7.
This overlapping does not compromise the integrity of the gaiter. When
properly tightened, it should be difcult to t a nger between the
pastern and the top of the gaiter.
8.
Due to their great deal of elasticity, gaiter straps cannot be over-tightened.
Trail Riding Lost Shoe Replacement Long Distance Events
Boot material
stretches for a
smooth, snug t
Speed Events Driving/Parades/Performance
Easyboot Glove
Tread has proven
successful over all
kinds of terrain
Reinforced Gaiter
incorporates molded
urethane components
for strength and stretch
EasyCare
easycareinc.com
© 2016 EasyCare Inc.
EASYCARE INC.
30-DAY MONEY-BACK GUARANTEE
EASYCARE INC.
30-Day Money-Back Guarantee
We back all of our products with a money-back guarantee. If you are not
completely satised with a product for any reason, you may return it for
a refund of the purchase price (excluding shipping and handling) within
30 days of purchase. To qualify, all products must be returned to place of
purchase and have a dated receipt. Offer not valid for EasyCare bargain bin
or factory seconds. If the product was purchased from EasyCare, contact
us at 800-447-8836 to receive return authorization and an RMA number.
All returns must have an RMA number clearly written on the outside of
package. Returns without an RMA number will be refused.
EASYCARE INC.
90-Day Warranty
EasyCare guarantees the quality and workmanship of all EasyCare products
for 90 days from date of purchase. While this warranty is very broad in
nature, it does not cover wear (including sole breakthrough when worn over
horseshoes), misuse, abuse, factory seconds, bargain bin items, or boots
purchased as used. Products returned for evaluation must be washed clean,
dry and free of debris, dirt, sand and manure. Damage inicted by omnivorous
horses, rodents or other unusual abuse is not covered. Customers in the
United States should contact EasyCare directly for all warranty issues at
800-447-8836. International customers should contact the dealer where
the product was purchased.
All products should be used in accordance with the instructions in this application
guide. EasyCare Inc. hereby disclaims responsibility for the misuse of any product
and for losses incurred through the use of any product described in this guide, on
EasyCare Inc. product packaging, or on easycareinc.com. EasyCare Inc. products are
not intended to diagnose or cure any medical condition.
Join the Conversation
For tips and tricks follow EasyCare:
Like Us on Facebook The EasyCare Blog
facebook.com/easyboot blog.easycareinc.com
HOW TO MEASURE FOR THE
EASYBOOT GLOVE
1. After a fresh trim, measure the width of the hoof across the sole
at the widest point.
2.
Measure the length of the hoof from
the toe to the buttress line of the heel.
The buttress line is the farthest weight
bearing point of the heel where the hoof
wall ends. Do not include the heel bulbs
in the measurement.
3.
Compare your measurement with the
size chart below.
4.
Ideally, the length and width measurement
will t into the same size. If the length and width measurements
indicate different sizes, select the larger size. If the width and
length measurements are different by more than one size, this boot
style is not recommended. Be sure to check your measurements
against an alternative boot in the EasyCare line – another style
may accommodate your horse’s hoof shape better.
Success of the Easyboot Glove and Easyboot Glue-On are determined
by accurate measurements and a snug t. Do not assume that if you
wear a certain size in another boot style, you will wear the same
size Glue-On or Glove. We have found that measurements are more
accurate and easier to take using the metric system.
Regular
Size Width in mm Length in mm
00 96-99mm 106-109mm
00.5 100-103mm 110-113mm
0 104-107mm 114-117mm
0.5 108-111mm 118-121mm
1 112-115mm 122-125mm
1.5 116-119mm 126-129mm
2 120-123mm 130-133mm
2.5 124-127mm 134-137mm
3 128-131mm 138-141mm
3.5 132-135mm 142-145mm
4 136-139mm 146-149mm
4.5 140-143mm 150-153mm
5 144-147mm 154-157mm
Size Width in mm Length in mm
0 114-117mm 114-117mm
0.5 118-121mm 118-121mm
1 122-125mm 122-125mm
1.5 126-129mm 126-129mm
2 130-133mm 130-133mm
2.5 134-137mm 134-137mm
3 138-141mm 138-141mm
Wide
Designed and tested in
Durango, Colorado USA
Glove
APPLICATION GUIDE
easycareinc.com 800.447.8836
Est. 1970
EasyCare
easycareinc.com
Loading...