Eastern Times Technology DS 2118 Users manual

Systems Compatibility

IBM PC and Win 95/98/Me/2000/XP, No need driver

Build-in mini receiver

As bellow, press the receiver-out button, and then the receiver

can spring out automatically, at this time, mouse begin to

work. If you push the receiver back to the transmitter, power will be cut down automatically.

he Steps of Install Battery

1. Please prepare for two PCS new AA alkaline batteries

2. Press the button of the mouse upper cover and pull the

battery cover rearward (Please see the reference picture)

3. Please insert the batteries correctly according to the

polarity marks of the battery grooves.

4. Pull the battery covers forward, when you hear “crack”

sound which shows the battery cover is locked successfully.

Setup

1. Please move the mouse near to the receiver

2. Press the ID button of the mouse bottom with some hard

and acuate object within 10 seconds, the receiver light will

flash very fast, a few seconds later it will be on which

shows it is successfully to finish the digital transmission

between the mouse and the receiver. You may start to use it.

3. 3. Working distance: within 0.6-1.5 m.

Attention Please

1. Please don’t make the mouse far away from the receiver in

order to work more smoothly.

2. You’d better use the mouse on the white desk, in this way the

batteries can be used longer time. Please remove the batteries if

the mouse will not be used for a long time.

3. This mouse with save power sleeping functions, please press any

key or scroll the wheel to wake up the mouse when it is sleeping.

4. If you want to take off the mouse power, please continue to

press the ID switch of the mouse bottom over 3 seconds. If

you want to take on the power, please click the ID switch

once again.

5. The optical mouse will not work freely on a smoot

desk ,glass, any reflecting surface, 3D mouse pad.

6. when you are moving the mouse, if the low-

light flickers, it shows that the batteries are using up, pleas

change another two new right batteries.

7. No need to check the digital connection within 10 second

when change the batteries, if more than that please accordin

to the above way to re-operate.

8. if you put the receiver into transmitter, power are cut dow automatically, and you can take them away.

Caution

Any changes or modifications not expressly approved by the part

responsible for compliance could void the user's authority t

operate the equipment.

Note

Note: This equipment has been tested and found to comply with th

limits for a Class B digital device, pursuant to part 15 of the FC

Rules. These limits are designed to provide reasonable protectio

against harmful interference in a residential installation. Thi

equipment generates, uses and can radiate radio frequency energ

and, if not installed and used in accordance with the instruction

may cause harmful interference to radio communications. Howeve

there is no guarantee that interference will not occur in a particul

installation. If this equipment does cause harmful interference t

radio or television reception, which can be determined by turnin

the equipment off and on, the user is encouraged to try to correct th

interference by one or more of the following measures:

* Reorient or relocate the receiving antenna.

ower indicatio