East Coast Supercharging SC1500 User Manual

www.EastCoastSupercharging.com

Phone [phone] • Fax [phone]

Directions for Installation of ECS Paxton Supercharger Kit

• Disconnect battery

• Remove stock serpentine belt

• Remove stock belt tensioner, save the 2 bolts for later use on supercharger bracket

• Remove alternator

• Remove cap from coolant reservoir and drain anti-freeze

• Remove stock air bridge & filter assembly saving the MAF sensor for later

• Remove upper radiator mount

• Remove bottom air dam from radiator support, save the four 10mm bolts for later use

• Remove front radiator shroud by taking all the 7mm bolts out (Figure 1)

• Remove front tires

• Remove front sway bar

• Remove electric cooling fans

www.EastCoastSupercharging.com

Phone [phone] • Fax [phone]

• Remove left & right splash shields exposing air pump & horns (Figure 2)

• Remove air pump and horns

• If equipped, remove power steering cooler from engine cradle to gain access to rack &

engine balancer

• Remove rack & pinion, make sure to loosen four 21mm cradle nuts & use a chisel to

space the front of the cradle down so that the rack clears more easily (Figure 3)

www.EastCoastSupercharging.com

Phone [phone] • Fax [phone]

• Remove balancer bolt (do not reuse)

• Pin crank with supplied bit and collar

• Install pin & install new balancer bolt, torque is 235 ft. lbs. (Figure 4)

• Remove lower radiator hose

• Cut & install supplied extender (Figure 5 & 6)

www.EastCoastSupercharging.com

Phone [phone] • Fax [phone]

• Replace thermostat with supplied 160°

• Reinstall lower hose, leaving radiator end off

• Remove lower radiator support, the radiator & condenser will hang in car

• With both hands straighten out the condenser line allowing the bottom of the radiator &

condenser to go forward, USE CAUTION THE A/C SYSTEM IS UNDER
PRESSURE (Figure 7)

• Reattach lower radiator hose

www.EastCoastSupercharging.com

Phone [phone] • Fax [phone]

• Relocate air pump to left side of new ECS radiator support using supplied ¼ - 20 riv-nuts

and bolts (Figure 8)

• Reference picture below to locate placement for air pump on radiator support (Figure 9)

www.EastCoastSupercharging.com

Phone [phone] • Fax [phone]

• Install new radiator support (Figure 10)

• Install supplied TiAL BOV on to ECS intercooler

• From the top, install intercooler with TiAL BOV & tighten bolts (Figure 11)

www.EastCoastSupercharging.com

Phone [phone] • Fax [phone]

• Modify lower air dam as shown & screw to radiator support with supplied screws (Figure

12 &13)

• Notch air dam for intercooler mounts (Figure 14)