EarthQuaker Devices Hoof Fuzz OPERATION MANUAL

Hey guy! Welcome to your new Hoof™ Fuzz Device! What to say about the Hoof that hasn’t already

been said? Our agship fuzz pedal can be found on thousands on pedaboards around the world and

has rocked countless stages from stinky suburban basements to Madison Square Garden. Twice.

The Hoof is loosely based on the classic green Russian fuzz circuit, and features a hybrid Germanium

/ Silicon design, pairing maximum tone with maximum temperature stability not found in nicky and expensive vintage units. We hand-match our NOS Germanium transistors to exacting specications for pedal-to-pedal consistency, taking the guesswork out of your fuzz purchase, and guaranteeing that

your Hoof delivers the same smooth, natural, and harmonically rich sustain as all your friends’ Hoofs. All your friends have Hoof fuzzes, right?

The Hoof has a wide gain range, providing everything from dirty and organic amp-like overdrive, to monstrous fuzz madness. This, paired with the “Shift” control allows you total tonal access, as the “Shift” knob works with the “Tone” control to alter the overall frequency response of the Hoof.

Use the “Shift” to boost the highs for a glassy, cutting top-end; use it to cut out some low-mid mud; use it to add some thick stoner rock sludge; use it on bass; use it to combat the muff-style fuzz’s notorious “mid scoop;” use it however you’d like, just use it! The Hoof’s distinctive, fuzzy character is tight and controlled without sacricing any “guts,” so to speak, so even the gnarliest fuzz tones will sit well in the mix.

The Hoof fuzz is all-analog, true bypass, and built one-at-a-time by real life human beans with four ngers and a thumb waiting in line for the horsey rides at the rustic frontierland amusement park of Akron, Ohio, USA. (The Ofcial Center of the Universe)

Controls

Fuzz: Clockwise for heavy, counterclockwise for light.

Tone: Bass to the left, Treble to the right

Level: Use this control to make the Hoof louder or quieter.

Shift: This adjusts the mid content, clockwise for scooped mids, counterclockwise for boosted.

Power

Our pedals take a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specic, transformer-isolated wall-wart power supplies or multiple isolatedoutput supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specic power supplies do not lter dirty power as well

and let through unwanted noise. Do not run at higher voltages!

Current draw

13mA

Switching

This device is true bypass and uses electronic relay based switching. Audio will not pass without power.