EarthQuaker Devices Arrows OPERATION MANUAL

™

Arrows

The Arrows is an all-discrete tone sculpting preamp booster. It was designed
with the intention of adding an additional channel of gain to all your dirt pedals
as well as brightening up neck pickups. It boosts midrange, tightens up the
low end and makes the top end shine while adding some push to drive your
dirt into blooming sustain with excellent harmonics. Its simple interface is no
nonsense; a single control that will either boost or cut your signal. Use the
Arrows to remove the muck from bass heavy fuzz pedals, push light overdrives
into higher gains than you thought possible or even on its own to make your
signal really pop with more pizazz. All analog, true bypass and handmade one
at a time in the weird pit of Akron, Ohio.

Controls

Level: Adjusts Arrows output level. Clockwise is loud, counterclockwise is quiet.

Switching

This device is true bypass and uses electronic relay based switching. Audio will
not pass without power.

Power

Arrows can be powered by a 9v battery or a standard 9-volt DC power supply

with a 2.1mm negative center barrel. We always recommend pedal-specic,

transformer-isolated wall-wart power supplies or multiple isolated-output
supplies. Pedals will make extra noise if there is ripple or unclean power.

Switching-type power supplies, daisy chains and non-pedal specic power
supplies do not lter dirty power as well and let through unwanted noise. Do

not run at higher voltages!

Current Draw: 2mA
Input impedance: 10M
Output impedance: <1K

Questions? Comments? Concerns?

Send an email to [e-mail] and we’ll help you out.

This device is guaranteed for life (or at least the life of EarthQuaker Devices).

© 2018 EarthQuaker Devices LLC. | www.earthquakerdevices.com | [e-mail]