Earnshaw ES-8001-33, ES-8001-08, ES-8001-01 User Manual

A) DISPLAY

JAPAN QUARTZ CHRONOGRAPH WITH DATE

Minute Hand

Hour Hand

Pusher A in stopwatch functon
Start/Stop

B) DATE & TIME SETTING

1. Pull out the crown to position 2.

2. Turn the crown clockwise until the previous day’s date appears.

3. Pull out the crown to position 3 when the second hand is at the 12 o’clock position. It will stop on the spot.

4. Turn the crown to set the hour, minute and 24-hour hands to the desired time. As the hour hand moves, the 24-hour hand also moves

correspondingly.

* When the crown is at position 3. Do not press any button. Otherwise, the chronograph hands will move.

5. Push the crown back into the position 1 in accordance with a time signal.

* Do not set the date between 9:00p.m. and 1:00a.m.. Otherwise, the day may not change properly. If it is necessary to set the date

during that time period, first change the time to any time outside it, set the date and then reset the correct time.

Stopwatch Minute Hand

Second Hand

Stopwatch Second Hand

1 2 3

Pusher B In Stopwatch Functon
Split/Split Release/Reset

24-Hour hand

C) HOW TO USE ST OP WATCH

- The measured time is indicated by the stopwatch hands that move indepently of the center and 24-hour hands.

- The stopwatch can measure up to 60 minutes in seconds.

I) Standard Measurement

1. Press Pusher A to start.

2. Press Pusher A to stop.

3. Press Pusher B to reset.

II) Accumulate elapsed time measurement

1. Press Pusher A to start.

2. Press Pusher A to stop.

3. Press Pusher A to restart.

(Restarting and stopping the stopwatch can be repeated as many time as necessary by pressing Pusher A. For resetting, please
press Pusher A to stop the stopwatch and then press Pusher B to reset.)

III) Split time measurement

1. Press Pusher A to start.

2. Press Pusher B to Split/Split Release.

3. Press Pusher A to stop.

4. Press Pusher B to reset.

(Measurement and release of the split time can be repeated as many times as necessary by pressing Pusher B.)

D) ADJUSTING THE STOPWATCH HAND POSITION

Before setting the time, check if the stopwatch and minute hands are at the “0” (12 o’clock) position. If the stopwatch is in use, please
stop and reset. If either of the stopwatch hands are not at the “0” position, reset them in the following steps:

1. Pull crown out to position 3.

2. Press Pusher A or B to reset the stopwatch second and minute hands to “0” position.
By pressing Pusher A, the hands move anti-clockwise.
By pressing Pusher B, the hands move clockwise.

3. Push the crown back to position 1.