Eago TB108, TB336 Certification

IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a
combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the
supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in
the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product
acceptance by Authorities Having Jurisdiction.

Effective Date: June 2011 -Rev. 12/16/2011- Void After: June 2012

Product: Ceramic Plumbing Fixtures File No. 4773

Issued To: Foshan Nanhai Eago Sanitary Ware Co. Ltd.

Shiling Industry District
Xiaotang Town, Nanhai Zone
Foshan City, GUANGDONG, 528222
China

IDENTIFICATION: The manufacturer's name or registered trademark, or, in the case of

private labeling, the name of the customer for whom the fixture was
manufactured, shall be applied so as to be legible, readily identified,
and located so as to be visible after installation.

The model number of each water closet, or bowl and tank model numbers in
the case of close-coupled water closets, shall be applied so as to be
legible and located so as to be visible after installation.

The date of manufacture (casting date) shall be applied so as to be
legible.

Each water closet and urinal shall be marked, identifying the water
consumption of the fixture. This disclosure shall be expressed in terms
of gallons and liters per flush [1.6 gpf(6.0 Lpf) for low-consumption
water closets, 3.5gpf(13.2 Lpf) for water-saving water closets, 1.0 gpf
(3.8 Lpf) for urinals] and shall be located in close proximity to the

For the most accurate and updated information please visit http://pld.iapmo.org/4773

This listing period is based upon the last date of the month indicated on the Effective Date and Void After Date shown above. Any change in material,
manufacturing process, marking or design without having first obtained the approval of the Product Certification Committee, or any evidence of
non-compliance with applicable codes and standards or of inferior workmanship, may be deemed sufficient cause for revocation of this listing.
Production of or reference to this form for advertising purposes may be made only by specific written permission of IAPMO Research and Testing, Inc.
Any alteration of this certificate could be grounds for revocation of the listing.

Page 2

-Rev. 12/16/2011-

Void After: June 2012

Product: Ceramic Plumbing Fixtures File No. 4773

Issued To: Foshan Nanhai Eago Sanitary Ware Co. Ltd.

manufacturer's name or registered trademark.

Each Gravity flush tank shall be permanently marked by the
manufacturer with a water level mark. This mark shall be applied to
the vitreous body in the tank, the tank liner, or the flush-valve
overflow tube. The vertical distance between the water level mark and
the lowers point of the tank overflow channel shall not exceed 1-1/2
in. (38mm).

These markings shall not be required to be permanent, but shall be
visible after installation. These markings shall be intended for
removal by the occupant only and shall so state. In the case of
close-coupled water closets, all nonpermanent markings shall only be
required to be applied on either the tank or the bowl.

All packaging for vitreous plumbing fixtures shall be marked with the
manufacturer's name or registered trademark, or, in the case of
private labeling, the name of the customer for whom the fixture was
manufactured, and the model number of the fixture. For water closets
and urinals, the appropriate water consumption, expressed in terms of
gallons and the liters per flush, as detailed in clause 9.3.2, shall
also be conspicuously marked on all packaging.

Listed products shall bear the cUPC® certification mark.